Storage Data Program - Skyrc Quattro B6AC Instruction Manual

STORAGE DATA PROGRAM

STORAGE DATA PROGRAM
For your convenience, SKYRC QUATTRO B6AC has a data storage and load program. It
can store five battery data representing the respective specifications of batteries. You can
call back the data when charging or discharging without setting up the program again.
Press START/ENTER key to make it blink, and use INC or DEC to set up the parameter.
PROGRAM SELECT
SAVE DATA
Start
Enter
SAVE [01] NiMH
14.4V 3000mHh
Voltage Data Capacity
number
Type of
battery
Batt type Start
'>3 seconds'
Stop Enter
NiMH CHARGE At*
CUR LIMIT 5.0A
- +
DEC INC DEC INC
NiMH DISCHARGE*
1.0A 11.0V
- + - +
DEC INC DEC INC
DEC INC
NiMH CYCLE *
DCHG>CHG 3
- + - +
DEC INC DEC
Start
'>3 seconds'
Enter
Save ...
LOAD DATA PROGRAM
This program is to load the data stored at the 'save data' program. Press START/ENTER
key to make the data field blink and press INC or DEC for more than 3 seconds to load the
data.
PROGRAM SELECT
LOAD DATA
Start
Enter
LOAD [01] NiMH
14.4V 3000mHh
Start
'>3 seconds'
Enter
Load ...
Setting of the parameter in the screen will not affect the charge
and discharge process. They just present the specification of the
battery. The example is NiMH battery pack, including 12 cells, the
capacity is 3000m Ah.
Set up the charge current in the manual mode, or current limit in
the auto mode. Press INC and DEC key simultaneously to make
the current field blink to switch the charge mode.
Set up the discharge current and final voltage.
Set up the charge/ discharge sequence and cycle number.
INC
Saving the data.
Choose the data number you want to call back. The data you
want to call back will be displayed.
Loading the data.