Charging Lithium Battery In The Charge Mode - Skyrc Quattro B6AC Instruction Manual

CHARGING LITHIUM BATTERY IN THE BALANCE MODE
This function is for balancing the voltage of Lithium-polymer battery cells while charging. In
the balance mode, the battery needs to have a balance lead to connect to the individual
balance port at the right side of the charger. And you need to connect the battery's power
lead to the output of charger. Charging in this mode is different from the normal mode. The
built-in processor monitors the voltage of individual cells and controls the input current fed
into each cell to equalized voltage.
BALANCE OF LITHIUM BATTERY
LiPo BALANCE
2.0A 11.1V(3S)
- + - +
DEC INC DEC INC
Batt type Start
'>3 seconds'
Stop Enter
R:3 SER S;3 SER
CONFIRM(ENTER)
Start
Enter
Li3s 1.2A 12.59V
CHG 022:43 00682
Number Charging Battery
of cells time voltage
Charging Charged
current capacity
CHARGING LITHIUM BATTERY IN THE BALANCE MODE
The left side of the first line shows the type of battery you
choose. The value on the left of the second line of the charger is
current user set, After setting the current and voltage, press
START/ENTER key for more than 3 seconds to start the
process.(charge current: 0.1-6.0A, voltage: 3.7-22.2V).
This displays the number of cells you set up and the processor
detects. "R" shows the number of cells detected by the charger
and "S" is the number of cells set by you at the previous screen.If
both numbers are identical you can start charging by press
START/ENTER button. If not, press BATT TYPE/STOP button to
go back to previous screen to carefully check the number of cells
of the battery pack before going ahead.
This screen shows the real-time status during charge process.
Press BATT TYPE/STOP key once to stop the charge process.