Fast Charging Of Lithium Battery - Skyrc Quattro B6AC Instruction Manual

FAST CHARGING OF LITHIUM BATTERY

CHARGING LITHIUM BATTERY IN THE FAST CHARGE MODE
Charging current will become lower when it progress to the end of charging. A specific CV
process will be reduced to end the charging process earlier. In fact, the charging current
will goes to 1/5 when the charging process comes to 1/10. Charging capacity will be little
smaller than normal charging, but charging time will be shortened accordingly.
FAST CHARGING OF LITHIUM BATTERY
LiPo FAST CHG
2.0A 11.1V(3S)
- + - +
DEC INC DEC INC
Batt type Start
'>3 seconds'
Stop Enter
R:3 SER S:3 SER
CONFIRM(ENTER)
Start
Enter
Li3s 2.0A 12.59V
FAS 022:43 00682
Number Charging Current
of cells time voltage
battery
Charging Supplied
current capacity
CHARGING LITHIUM BATTERY IN THE STORAGE MODE
This function is for charging/discharging batteries which are not used at once. This
program is designed for charging or discharging of batteries of specific original state. They
are classified by types:3.75V Lilo, 3.85V LiPo and 3.3V LiFe. The program will begin to
discharge if the original state of the battery exceeds the voltage level of storage.
STORAGE CONTROL OF LITHIUM BATTERY
LiPo STORAGE
1.0A 11.1V(3S)
- + - +
DEC INC DEC INC
Batt type Start
'>3 seconds'
Stop Enter
Li3s 1.0A 12.59V
STO 0.22:43 00682
Number Elapsed Current
of cells time voltage
battery
Charge or Supplied
discharge capacity
current
The value on the left side of the second lines sets the charge
current. The value on the right side of the second lines sets the
battery pack's voltage. After setting current and voltage, press
STAR/ENTER for more than 3 seconds to start the process.
This displays the number of cells you set up and the processor
detects. 'R' shows the number of cells detected by the charger
and 'S' is the number of cells set by you at the previous screen. If
both numbers are identical, you can start charging by press
START/ENTER button. If not, press BATT TYPE/STOP button to
go back to previous screen to carefully check the number of cells
of the battery pack before going ahead.
This screen shows the real-time status during charge process.
Press BATT TYPE/STOP key once to stop the charge process.
At this screen, you can set up the current and voltage of the
battery pack. Charging and discharging will make the batteries
come to the voltage level of 'storage' state.
This screen shows the real-time status charging. Press BATT
TYPE/STOP key once to stop the charge process.