Lithium Polymer Balance Charge Program - Skyrc Quattro B6AC Instruction Manual

LITHIUM POLYMER BALANCE CHARGE PROGRAM

CONNECTION DIAGRAM
CONNECTING THE CHARGER
SKYRC QUATTRO B6AC comes with the built in switching power supply. You can connect
the AC power cord directly to the main AC socket. (100-120V AC US Version or 220-240V
AC EU Version) For attaching directly to 12V car batteries
use a fully charged 13.8V car battery
CONNECTING THE BATTERY
!!!
Important Before connecting a battery it is absolutely essential to check one last time
that you have set the parameters correctly
,
be damaged and could even burst into flames or explode
the banana plugs
.
the battery Reverse the sequence when disconnecting the pack
Balance socket:
The balance wire attached to the battery must be connected to the charger with the black
wire aligned with the negative marking. T ake care to maintain correct polarity! (See the
wiring diagram below.)
This diagram shows the correct way to connect your battery to the SKYRC QUATTRO
B6AC while charging in the balance charge program mode only.
WARNING:
Failure to connect as shown in this diagram will damage this charger.
,
always connect the charge leads to the charger first
.
It is critically important that you
Using terminal
clip attaching
to car battery
.
If the settings are incorrect
.
To avoid short circuits between
,
the battery may
,
and only then to
.