Table of Contents
Advertisement
PAGE 42
MARQUIS SPAS
troubleshooting
PLEASE NOTE: The following corrective actions
may be performed by the spa owner. If the trouble
cannot be corrected in the steps below, please
contact your Marquis spa dealer for service. (Im-
proper servicing by an unauthorized service provider
or spa owner could result in damage not covered by
the warranty and could cause serious injury.)
EQUIPMENT WILL NOT OPERATE
• Check the control panel LCD window for
diagnostic code.
• 240V Spas: Check the circuit breaker on the
main circuit panel.
• 120V Spas: Check the GFCI power cord and
reset if necessary (see IMPORTANT SAFETY
INSTRUCTIONS at beginning of manual).
• Check the condition of the power cord.
INADEQUATE JET ACTION
• Be sure the shut-off valves are completely open.
• Open the jets by turning the jet face to allow for
maximum water flow.
• Check that the air control valve is open (rotate
lever counterclockwise to open).
• Check for obstruction or restrictions at suction
guard(s) or filters, such as leaves, etc.
NO HEAT
• Check temperature displayed in the LCD window
for desired temperature setting.
• Inspect the filter cartridge(s) for dirt and debris.
• Check that the water is at proper level, 2/3 up
the Vortex skimmer opening(s).
• Lower ambient temperatures may result in heat loss.
NOTE: Do not expect instant hot water from the
jets. It will take the heater 12-24 hours to heat the
water to the temperature you desire.
LIGHT DOES NOT WORK
• Press the LIGHT pad on the control panel.
• Reposition the light bulb in the socket. (See
REPLACING LIGHT BULB.)
• Replace the light bulb with a 6 WATT BULB (GE
918 ONLY).
Hide quick links:
Advertisement
Table of Contents
