Table of Contents
Advertisement
s p o r t s E R I E s C O N T R O L S
PROGRAMMABLE FILTER TIMES
F1: 45 minutes
•To adjust the filter time: First press the TEMP SET pad, then press the ZONE 1 JETS.
•The LCD display will show either F1 (45 minutes), F2 (two hours), F4 (four hours),
or F6 (six hours). Press the TEMP SET pad to scroll through the selections and then
press the ZONE 1 JETS pad to enter.
• The display will now show either 2C (two filter cycles per day), 1d (one cycle per
day that will start one minute after power up) or 1n (one cycle per day that starts 12
hours after power up). Press the TEMP SET pad to scroll through the selections and
press ZONE 1 JETS pad to enter.
•The display will now show either 4H (four hour cycle), 3H (three hour cycle), 2H
(two hour cycle), 1H (one hour cycle) or 0H (smart cycle off). Press the TEMP SET
pad to scroll through the selections and then press the ZONE 1 JETS pad to set and
exit the programming mode.
Factory default settings for the above selections: Filtration time F2 (two hours);
Filter cycles 2C (two times per day); Cleanup cycle “Smart Logic” 4H (four hours)
NOTE: In event of a power outage, all settings will revert to the preset, default settings.
TEMPERATURE DISPLAY AND ADJUSTMENT
The LCD window displays the actual water temperature. Pressing the TEMP SET pad
will make the numbers flash, then pressing the pad again (repeatedly) will increase the
set temperature one degree at a time, up to 104° F. After a short pause, the actual
temperature will again be displayed. Repeating the above procedure will allow you to
decrease the set temperature.
SOAK TIMER AND SOAK FEATURE
Pressing the SOAK TIMER pad will turn the jet pump to low-speed and start a 59-
minute timer. The timer will display the elapsed time in one-minute increments (1-14).
After 15 minutes, the display will flash the minute (15-59) for ten seconds before
switching to a steady display as a safety reminder to not overstay your soak. During the
Soak Timer mode, the temperature display can be checked by pressing the TEMP SET pad.
A second press of the SOAK TIMER pad will turn off all functions (except light) for an all-
quiet soak. Pressing any pad will cancel the Soak mode.
HEAT LIGHT
The HEAT ON light will illuminate when the heater is on.
LCD DIAGNOSTIC MESSAGES
The advanced technology built into the spa allows it to perform a number of self-
diagnostic system checks and it can display a variety of messages on the LCD panel. See
TROUBLESHOOTING section for descriptions.
MAINTENANCE REMINDERS
Maintenance Reminders help remind you of routine maintenance procedures.
CL:
Will appear every 30 days to remind you to clean the filter.*
CH:
Will appear every 90 days to remind you to change the spa water.*
*NOTE: In event of a power outage, all settings will revert to the preset, default settings.
REMOTE CONTROL
Optional Remote Control operates exactly the same as the Sport Spas Control.
M A R Q U I S
F2: 2 hours
S P A S
•
R E L A X I N G
F4: 4 hours
Y O U R
W O R L D
F6: 6 hours
3 2
Hide quick links:
Advertisement
Table of Contents
