Table of Contents
Advertisement
spa control operation
Use the TEMP+- pad to scroll through filter cycle
options. When desired selection has been reached,
press the SETTING pad to enter selection and ad-
vance to the smart logic settings.
Selectable filter cycles and cycle duration
• 2C: twice per day (once every 12 hours)
• 1d: once during the day
• 1n: once during the night
• F1: 45 minutes
• F2: 2 hours
• F4: 4 hours
• F6: 6 hours
SMARTCLEAN™
Since a spa is always covered when not in use, it stays
fairly free of debris or outside contamination. Contami-
nation to a spa's water occurs during usage, so
filtering immediately after usage is the most effective
time to clean the spa water. Your spa is preset at the
factory with a default setting to filter for one hour (1H)
every time your spa is used. This filtration cycle begins
30 minutes after the spa light or jet pump has been
deactivated. The pump runs on low-speed to filter the
water for the cycle's duration.
Selectable SmartClean Settings
• 1H: 1 hour
• 2H: 2 hours
• 3H: 3 hours
• 4H: 4 hours
• OH: Off
To adjust the SmartClean settings:
Use the TEMP+- pad to scroll through options. When
desired selection has been reached. Press SETTING
pad to enter selection and exit settings mode.
TEMPERATURE DISPLAY AND ADJUSTMENT
Factory Default Settings:
• Temperature: 102°F (39°C)
The LCD window displays the actual water tempera-
ture. Pressing the TEMP+- pad makes the numbers
flash, then pressing the pad again (repeatedly)
increases the set temperature one degree at a time,
up to 104°F (40°C). After a short pause, the actual
temperature displays. Press TEMP+- pad repeatedly
to decrease the set temperature to 80°F (27°C).
HEAT LIGHT
The HEAT light illuminates when the heater is on. The
pump circulates on low-speed whenever the thermo-
PAGE 29
stat calls for heat.
M A R Q U I S S P A S
Hide quick links:
Advertisement
Table of Contents
