Table of Contents
Advertisement
PAGE 56
MARQUIS SPAS
marquis care and enjoyment guide
FAILURE TO GET A SANITIZER READING ON
TEST STRIP
C: Sanitizer level is too low.
S: Add bromine until the sanitizer registers in the
recommended range on the test strip.
C: Algae present.
S: Dirty water consumes the sanitizer as soon as
it is added. Add more bromine until the sanitizer
registers and stays in the recommended range
on the test strip.
C: Test strip remains "white" even after sanitizer
has been added.
S: Sanitizer level is extremely high. It can bleach
the reagents on the test strip and give a false
reading. (See below.)
TOO MUCH SANITIZER IN THE WATER
C: Too much bromine added or dispensed into
the spa.
S: Remove spa cover and bromine cartridge.
Activate jets and air control. Allow jets to run for
30 minutes. Test water with a Water Test Strip
to see if desired level has been reached.
EYE OR SKIN IRRITATION
C: Contaminants or excessive amount of
chloramines/bromamines in water.
S: Treat water with Spa Shock. Adjust sanitizer level.
C: pH level is low.
S: Adjust pH level as needed.
CORROSION OF METAL
C: Low pH level.
S: Adjust pH level with pH and Alkalinity Up.
GREEN WATER/ALGAE
C: Low sanitizer level or high pH.
S: Adjust pH and sanitizer as necessary.
ERRATIC pH TEST COLOR
C: Sanitizer level is too high. (See TOO MUCH
SANITIZER IN THE WATER.)
S: Test pH again when sanitizer level is below 5 ppm.
Hide quick links:
Advertisement
Table of Contents
