Marquis Spas THE QUEST Operating And Troubleshooting Manual page 7

spa control operation
SETTINGS
Clock
Press the CLOCK pad followed by the SETTING pad.
"Program" will be shown in the upper left corner of the
panel display and the hour will begin flashing. To
adjust, press the TEMP+ or TEMP- pad. Once the
correct hour has been set, press SETTING pad to set
the minutes. "Minutes" will flash. Follow above proce-
dure to set the correct minutes.
Filter Cycle 1:
Follow Clock programming above. Then press the
SETTING pad to enter Filter 1 programming mode.
"Program filter 1 start time" will be shown in the upper
left corner of the panel display and the hour will begin
flashing. To adjust press the TEMP+ or TEMP- pads.
Once the correct hour has been set press SETTINGS
pad to set the minutes. Follow above procedure to set
the correct minutes. Press the SETTING pad again
and "Program filter 1 end time" will be shown in the
upper left corner of the panel display and the hour will
begin flashing. Follow above procedures to set the
correct hour and minutes. NOTE: When in a filter cycle
the Filter Cycle LED will illuminate.
Filter Cycle 2:
Press SETTING pad to enter filter 2 programming
mode. "Program filter 2 start time" will be shown in the
upper left hand corner of the panel display and the
hour will begin flashing. Follow above procedure to set
the correct hour and minutes. Press the SETTING pad
again and "Program filter 2 end time" will be shown in
the upper left corner of the panel display. Follow above
procedure to set correct hour and minutes.
Spa Light:
Press SETTING pad to enter spa light programming
mode. The light icon will begin flashing at the bottom
of the panel display. "Start time" will be shown in the
upper left hand corner of the panel display and the
hour will begin flashing. Follow above procedure to set
the correct hour and minutes. Press the SETTING pad
again and "end time" will be shown in the upper left
corner of the panel display and the hour will begin
flashing. Follow above procedure to set the correct
hour and minutes. Press the CLOCK pad to exit the
programming mode.
NOTE: Any time during the setting of features you
may exit the programming mode by pressing the
CLOCK pad. If you don not want to run any of the filter
modes or spa light cycles, set the start and end times
PAGE 33
for the same time.
MARQUIS SPAS