Removing Other Components (Hp Authorized Service Providers Only); Table 2-6. Other Replaceable Components (Authorized Providers) - HP OmniBook 3000 Service Manual

Removing Other Components
(HP Authorized Service Providers Only)
The following table lists additional replaceable components and the removal procedures required to
access them.

Table 2-6. Other Replaceable Components (Authorized Providers)

Component
AC Adapter
Audio Jack Holder
Audio PCA
CPU Module
Display Latch or
Spring
Hinge
Icon/MB Cable
HP OmniBook 3000
Equipment Removal Procedures
Phillips screwdriver, Plug-in module (page 2-3).
5 mm hex driver
Hard drive (page 2-4).
Display (page 2-8).
Keyboard (page 2-11).
Top case (page 2-17).
Motherboard (page 2-20).
Phillips screwdriver, Plug-in module (page 2-3).
5 mm hex driver
Hard drive (page 2-4).
Display (page 2-8).
Keyboard (page 2-11).
Top case (page 2-17).
Motherboard (page 2-20).
Phillips screwdriver Plug-in module (page 2-3).
Hard drive (page 2-4).
Display (page 2-8).
Keyboard (page 2-11).
Top case (page 2-17).
Phillips screwdriver Plug-in module (page 2-3).
Hard drive (page 2-4).
Display (page 2-8).
Keyboard (page 2-11).
Top case (page 2-17).
Phillips screwdriver Plug-in module (page 2-3).
LCD module, but only until
the display bezel is
removed (page 2-11).
Phillips screwdriver Plug-in module (page 2-3).
Display, but only until the
icon PCA is removed
(page 2-8).
Special Notes
No repairable components.
Replacement is required.
Remove the motherboard
only far enough to slip the
holder off the audio jacks.
Unplug audio PCA from
underside of motherboard.
Check that two rubber
bumpers are present on the
new audio PCA directly
behind the two connectors.
Remove two screws from
CPU module. Unplug CPU
module from motherboard.
Caution: Install both parts of
a CPU thermal kit (F1391-
60917) to the new module.
Stick the gasket to the top of
the CPU. Stick the rubber
spacer to the top back-right
corner of the board.
To remove, lift the left corner.
To install, put the spring on
the latch shaft, then insert the
shaft through the opening at
the bottom of the right-hand
slot.
Caution: If the display is
attached to the bottom case,
install one new hinge before
you remove the other to avoid
stressing the cables.
Install the hinge so the slit in
the housing faces into the
display case.
The display does not have to
be removed.
Removal and Replacement 2-27