Figure 2-8. Removing The Icon Pca And Display Assembly - HP OmniBook 3000 Service Manual

8. For the inverter/MB cable emerging from the right hinge, unplug the cable from the motherboard.
9. Remove the four screws from the hinges, and lift off the display assembly.
Icon PCA
F1391-60911
Screw, M2.5×5mm
F1391-60951 (2)

Figure 2-8. Removing the Icon PCA and Display Assembly

Reassembly Notes
• After connecting the inverter/MB cable from the right hinge, carefully dress the wires into the
cutout and support in the case.
Caution
Use a 5 mm screw to fasten the grounding lug through the LVDS PCA. If you use a longer screw,
it will damage the motherboard.
Do not overtighten the grounding screw for the LCD/LVDS cable from the left hinge. It fastens to
a sheet-metal bracket and the threads could strip.
• Insert the right end of the icon PCA between the plastic tabs on the case. Check that the IR/icon
cable is not pinched and emerges above the PCA.
• Slide the open end of the hinge cover onto the hinge, then lift the closed end over the bump and slide
it in.
2-10 Removal and Replacement
Screw, M2.5×8mm
F1391-60957 (4)
HP OmniBook 3000