Removing Other Components (Hp Authorized Service Providers Only); Figure 2-16. Boot-Block Jumper; Table 2-9. Removing Display Components - HP OMNIBOOK 4100 Service Manual

Removing Other Components
(HP Authorized Service Providers Only)
Required Equipment
Small Phillips screwdriver.
Pointed knife or probe (for display components).
5-mm hex driver (or 3/16 inch) (for bottom case components).
Removal Procedure
1. Unplug the ac adapter, if present, and remove the battery.
2. Remove the additional assemblies and follow the special steps indicated in the tables below.
Components are separated into these groups:
Display components (below).
Top case components (page 2-32).
Bottom case components (page 2-33).
Component
Cable Holder
(part of display case kit)
Display Bezel
Display Case
HP OmniBook 4100/4150
1
14

Figure 2-16. Boot-Block Jumper

Table 2-9. Removing Display Components

Removal Procedures
Display (page 2-11).
Display (page 2-11)
Display (page 2-11).
13
25
Additional Steps (See figure on page 4-7)
1. Remove the display bezel (page 2-13).
2. Unsnap the cover of the cable holder.
3. Use a flat-blade screwdriver to pry the display case
and release the cable holder.
Reassembly Notes: Install the holder so the tabbed
side is toward the bottom of the display case.
Remove the display bezel (page 2-13).
Caution: Use compatible parts (page 2-13).
Remove the LCD module and brackets from the case,
but do not disassemble the module (page 2-13).
Reassembly Notes: Transfer the display latch and
cable holder from the old display case.
Caution: Use compatible parts (page 2-13).
Removal and Replacement 2-31