HP OmniBook 3000 Service Manual page 46

Component
Icon PCA
Inverter/MB Cable
Inverter PCA
IR/Icon Cable
IR Lens
IR PCA
LCD/LVDS Cable
Lock Plate
2-28 Removal and Replacement
Equipment Removal Procedures
Phillips screwdriver Plug-in module (page 2-3).
Display, but only until the
icon PCA is removed
(page 2-8).
Phillips screwdriver, Plug-in module (page 2-3).
Knife or probe,
Display (page 2-8).
3 flat screwdrivers
LCD module (page 2-11).
Display case (page 2-13).
Phillips screwdriver, Plug-in module (page 2-3).
Knife or probe
LCD module (page 2-11).
Phillips screwdriver Plug-in module (page 2-3).
Hard drive (page 2-4).
Display (page 2-8).
Keyboard (page 2-11).
Top case (page 2-17).
Phillips screwdriver Plug-in module (page 2-3).
Hard drive (page 2-4).
Display (page 2-8).
Keyboard (page 2-11).
Top case (page 2-17).
Phillips screwdriver Plug-in module (page 2-3).
Hard drive (page 2-4).
Display (page 2-8).
Keyboard (page 2-11).
Top case (page 2-17).
Phillips screwdriver, Plug-in module (page 2-3).
Knife or probe
Display (page 2-8).
LCD module (page 2-11).
Phillips screwdriver Plug-in module (page 2-3).
Hard drive (page 2-4).
Display (page 2-8).
Keyboard (page 2-11).
Top case (page 2-17).
Motherboard, but only until
you can lift the front edge
(page 2-20).
Special Notes
The display does not have to
be removed.
The cable should protrude
about 6 cm from the hinge.
Secure the inverter/MB cable
to the case near the hinge
area with a piece of Kapton
tape.
Unsnap the inverter PCA from
the display case, then unplug
the cable.
Install an inverter bumper
(F1391-60960) on the PCA.
Remove the screws from the
IR PCA and the speaker
bracket.
Make sure the cable is
clamped by the bracket, and it
routes through the bottom
corner of the window opening.
The lens should be flush with
the outside of the case.
The IR PCA fits onto the pin
on the top case
The cable should protrude
about 6 cm from the hinge.
Secure the LCD/LVDS cable
to the LCD bracket with a
piece of Kapton tape near the
hinge.
Secure the LCD/LVDS cable
to the LCD module with a
piece of Kapton tape next to
the LCD connector.
Pull up on the lock plate until
it comes out of the bottom
case. It wedges into place.
HP OmniBook 3000