Figure 2-12. Removing The Display Case And Lcd Bracket - HP OmniBook 3000 Service Manual

Hp omnibook 3000

Hide thumbs Also See for OmniBook 3000:

Reference manual (133 pages)

User handbook manual (59 pages)

User manual (32 pages)

Table Of Contents

Table of Contents

LCD/LVDS Cable

F1391-60961

Screw, M2.5×5mm

F1391-60951 (4)

Inverter/MB Cable

F1391-60959

Hinge

F1391-60925 (2)

Display Case

F1391-60910

Reassembly Notes

• Before you install the LCD bracket, secure the inverter/MB cable to the case near the hinge area

with a piece of Kapton tape.

• Make sure the EPE foam is not placed under the LCD bracket. The two flaps go on top of the

bracket.

• After you install the LCD bracket, secure the LCD/LVDS cable to the bracket near the hinge area

with a piece of Kapton tape.

• Position the two cables correctly before you install the hinge screws. Both cables should protrude

from the case almost 6 cm (about 2 inches).

• Install each hinge so the slit in the housing faces into the display case.

• Before installing the LCD module, make sure the EPE foam is properly positioned inside the LCD

bracket. The two flaps should be on top of the center bar of the bracket.

• Secure the LCD/LVDS cable to the LCD module with a piece of Kapton tape next to the LCD

connector.

• Position the cables properly in the hinges before installing the bezel.

• Make sure the bezel snaps to the case along all edges. Pull to the side to help seat the snaps.

• Make sure the screw covers stick securely in place.

HP OmniBook 3000