Removing Other Components (Hp Authorized Service Providers Only); Table 2-5. Removing Omnibook Components - HP Omnibook XT6050 Service Manual

Removing Other Components
(HP Authorized Service Providers Only)
Required Equipment
Small Phillips screwdriver.
Small flat-blade screwdriver.
Removal Procedure
1. Unplug the AC adapter, if present, and remove the battery and any secondary battery module.
2. Remove the assemblies and follow the additional steps given in the table below.
Component
Battery, CMOS
Card, mini-PCI #2
Case, bottom
Case, top
Cover, center hinge
CPU module
Display assembly
Doors, docking
HP Omnibook XT6050, XT/VT6200

Table 2-5. Removing Omnibook Components

Removal Procedure
Power button panel
(page 2-11).
Keyboard (page 2-13).
Heatsink (page 2-15).
Plug-in module
(page 2-5).
Hard disk drive (page 2-7).
Power button panel
(page 2-11).
Keyboard (page 2-13).
Heatsink (page 2-15).
Display assembly
(page 2-19).
Top case (page 2-21).
Motherboard (page 2-23).
See page 2-23.
See page 2-21.
Power button panel
(page 2-11).
Display assembly
(page 2-19).
See page 2-17.
See page 2-19.
Plug-in module
(page 2-5).
Hard disk drive (page 2-7).
Power button panel
(page 2-11).
Keyboard (page 2-13).
Heatsink (page 2-15).
Display assembly
(page 2-19).
Top case (page 2-21).
Additional Steps
Reassembly Notes: After replacing the CMOS
battery, set the correct time and date using the BIOS
Setup utility or Date/Time in the Control Panel.
The card is attached to the underside of the
motherboard. Release the two latches at the sides of
the card so the free edge of the card pops up.
Reassembly Note: Make sure the center hinge cover
fits over the tab in the bottom case.
See the figure on page 2-25.
Removal and Replacement 2-31