Removing Other Components (Hp Authorized Service Providers Only); Table 2-7. Removing Display Components; Table 2-8. Removing Top Case Components; Table 2-9. Removing Bottom Case Components - HP omnibook OmniBook XE2 Service Manual

Removing Other Components
(HP Authorized Service Providers Only)
Required Equipment
Small Phillips screwdriver.
Pointed knife or probe (for display components).
5-mm hex driver (or 3/16 inch) (for bottom case components).
Removal Procedure
1. Unplug the AC adapter, if present, and remove the battery.
2. Remove the additional assemblies and follow the special steps indicated in the tables below.
Components are separated into these groups:
Display components.
Top case components.
Bottom case components.
Component
Display Bezel
Display Case
Hinge
Hinge Cover
Inverter PCA
LCD Brackets
(part of LCD kit)
LCD Flex Cable
LCD Module
Component
Keyboard
Top Case
Component
Battery
HP OmniBook XE2

Table 2-7. Removing Display Components

Removal Procedures
Display (page 2-11)
LCD module (page 2-12).
Display (page 2-11).
LCD module (page 2-12).
Display (page 2-11).
LCD module (page 2-12).
Display (page 2-11).
Display (page 2-11).
LCD module (page 2-12).
Display (page 2-11).
LCD module (page 2-12).
Display (page 2-11).
LCD module (page 2-12).
See page 2-12.

Table 2-8. Removing Top Case Components

Removal Procedures
See page 2-9.
See page 2-15.

Table 2-9. Removing Bottom Case Components

Removal Procedures
See page 2-3.
Additional Steps (See figure on page 4-3)
Remove the display bezel (page 2-12)..
Remove the LCD module and brackets from the case,
but do not disassemble the module (page 2-12).
Remove the display bezel (page 2-12).
1. Remove the display bezel (page 2-12).
2. Unplug both cables attached to or holding the
inverter PCA. Lift up the PCA if necessary.
Additional Steps
Additional Steps (See figures on pages 4-2, 4-4)
Removal and Replacement 2-21