Operation - Webb WER21HW Operator's Manual

• Lower the flap to lock the grassbox in position.
• When the box is full, the grass will be visible through the viewing window in the top of the box.
• Stop the engine before emptying the grassbox.
2. Rear Discharge:
• Ensure that the side cover is closed.
• With the grassbox removed and the rear flap in the down position, the mower will cut and discharge the
grass from the rear of the machine.
3. Side Discharge:
• Fit the mulch plug to the rear discharge opening of the mower and close the rear flap.
• Lift the cover on the side of the mower and attach the side discharge chute as shown in the diagram.
• The mower will now eject grass from the side discharge chute.
4. Mulching:
• Fit the mulch plug as in step 3 above.
• Ensure that the side cover is in the closed position (with the discharge chute removed).
• The mower will now recycle the chopped grass into the lawn surface.
• To mulch efficiently only cut one third of the length of the grass.
SET UP YOUR MOWER
IMPORTANT: Unfold the handle carefully so
as not to pinch or damage the control cables.
1. Depress the Operator Presence Control Bar
(OPC) and raise the handles until the lower handle
section locks into place at the mowing position.
2. With the Operator Presence Control Bar still
depressed raise the upper handle section into place
on the lower handle and tighten both handle knobs.

Operation

Brake lever - must be held down to the handle to start the engine. Release to stop the engine.
Starter handle - used for starting the engine.
Drive control lever - used to engage the self-propel system.
USE YOUR LAWNMOWER ENGINE SPEED
The engine speed was set at the factory for optimum performance. Speed is not adjustable.
5
Drive lever
Push handle
Operator Presence
Control Bar