Installation Steps; Remove The Frame; Install The Frame; Install The Air Filter And Front Panel - Kelvinator Reverse Cycle User Manual

1. Hold the slot under the front panel, then uplift it outwards, and remove the front panel (See Fig.3).
2. Pinch the handle under the air filter and make the air filter arched, remove it from the slot from
underside to upside (See Fig.4).
In-line Connector
1. Remove the one fixing screws from the frame (See Fig.5).
2. Grasp the left corner of the frame's underside, then loosen the frame and carefully disconnect
the connector (See Fig.6).
1. Remove the two fixing screws on the chassis fixing brackets (9,000Btu/h and 12,000 Btu/h models,
See Fig.7) or remove the two fixing screws on the side of cabinet (≥16,000Btu/h model) or
remove the two screws on the back of cabinet (if fitted. These screws are not needed to install
in later installation), then remove the chassis fixing brackets.
2. Grasp the handle on the chassis and carefully slide the air conditioner out of the cabinet
(See Fig.8).
3. Remove shipping pad (if fitted ) from around compressor before operation (Failure to do so
may damage the Compressor ) And make sure the discharge points to the drain pan are
aligned before the chassis is pushed into the cabinet (See Fig.9).
4. Push the unit chass is into the cabinet (See Fig.10).
5. Fix the chassis with the screws previously removed as they were prior to removal.
(Top view)
1. Install the frame making sure not to interfere with the
temperature sensor (See Fig.11).
2. Fix the screws on the frame (See Fig.5). For
models, the screws are supplied with the unit.
1. Install the air filter into the frame's slot from upside to
underside (See Fig.4).
2. Hang the front panel on the frame's buckle, then press the
front panel into the frame's slot until you hear a click (See Fig12).
Fig. 3
Fig. 6
Foam
Compressor
Fig. 9
Fig. 4
Fig. 7
Fig. 10
12,000 Btu/h
16
Fig. 5
Fig. 8
Fig. 11
Fig. 12