JVC GR-DV2000 Instructions Manual page 30

30
RECORDING
EN
Power Switch
SNAPSHOT
Button
Recording Start/Stop Button
Display
SEL F – T I MER – OF F
ON
When the Recording Start/Stop
Button or SNAPSHOT is pressed,
the tally lamp changes as shown:
MENU Wheel
Begins blinking
4
(Self-Timer starts)
Shooting
Mode Switch
Lock Button
Menu Screen
Self-Timer
indication
4
Blinks quickly
4
(Self-Timer shooting
starts soon)
4
After approx. 15 sec.
Advanced Features For Video And D.S.C. (cont.)
Self-Timer
Once the camcorder is set, the camcorder operator can
become part of the scene in a more natural way, adding
the final touch to a memorable picture.
1
Set the Power Switch to "
the Lock Button located on the switch. Pull out the
viewfinder fully or open the LCD monitor fully.
•You can tilt the LCD monitor upward to 180° so that
it faces forward and view yourself while self-
recording.
2
Press the MENU wheel. The Menu Screen appears.
3
Rotate the MENU wheel to select "
and press it.
4
Rotate the MENU wheel to select "SELF-TIMER", and
press it. The Sub Menu appears. Rotate the MENU
wheel to select "ON
complete. Rotate the MENU wheel to select
"1RETURN", and press it twice to close the Menu
Screen.
5
To engage the Self-Timer for video recording, press
the Recording Start/Stop Button. After 15 seconds, the
beep sounds and video recording starts. To stop Self-
Timer recording, press the Recording Start/Stop
Button again. The camcorder re-enters Record-
Standby mode.
OR
Press SNAPSHOT. After 15 seconds, the beep sounds
and snapshot recording starts. After that, the
camcorder re-enters Record-Standby mode.
6
To end Self-Timer recording, select "OFF" in step 4.
NOTE:
If "BEEP" and "TALLY" are set to "OFF" (
beep does not sound and the tally lamp does not light.
Turns off
(Self-Timer snapshot recording starts)
Stops blinking and stays on
(Self-Timer video record-ing starts)
" while pressing down
MANUAL",
", and press it. Selection is
pg. 29), the