JVC GR-DV2000 Instructions Manual page 24

24
RECORDING
EN
Power Switch
SNAPSHOT
Button
Lock Button
Video image
Still image
FOCUS Ring
Advanced Features For Video And D.S.C. (cont.)
Shooting
Mode Switch
SNAPSHOT Button
Released position
Half-pressed
position
Fully-pressed
position
FOCUS Button
Dual Shooting
Lets you record images on a tape and store still images in a
memory card simultaneously. In other words, it is possible
to store still images in the memory card without
interrupting image recording on the tape.
1
Set the Shooting Mode Switch to "VIDEO", then set
the Power Switch to "
Lock Button located on the switch. Pull out the
viewfinder fully or open the LCD monitor fully.
2
Set "CAMERA MODE" to "DUAL" in the Menu
Screen ( pg. 26, 27).
3
While recording to a tape, press SNAPSHOT halfway.
A still image is displayed in the lower right corner of
the screen where the video image being recorded is
displayed.
•At this moment, if you release SNAPSHOT,
snapshot recording will be cancelled.
4
Press SNAPSHOT fully. The displayed still image is
stored in the memory card.
NOTES:
If SNAPSHOT is pressed in the Record-Standby mode,
only a still image is stored in the memory card. Video
recording does not take place.
If SNAPSHOT is pressed when "DIS" is set to "ON"
( pg. 27), the Stabiliser will be disabled.
The Stabiliser is less effective in the DUAL mode than in
other modes.
Still images are stored in the memory card in VGA mode
file size ( pg. 12).
When "CAMERA MODE" is set to "DUAL", all Fade/
Wipe Effects and some Programme AE with special
effects cannot be used (
The optional flash (
video recording.
" while pressing down the
pg. 32 – 35).
pg. 3, 83) will not light during