Front Cover - Graco 248650 Repair And Parts Manual

Removing and Replacing Hopper, Front and Back Covers
Removing and Replacing Hopper, Front and Back
Covers
Before performing any service on sprayer
always:
• Read all warnings, page 2.
• Read operating instructions manual 310716.
• Relieve Pressure, page 6.
• Turn main power switch (A) OFF.
• Unplug sprayer from outlet.
• Remove air and material hoses.
• Clean sprayer. See Operation Manual 310624 or
310625.
Hopper
Removing Hopper
1. To remove hop-
per loosen fit-
ting. Fittings are
hand-tightened
and should not
require tools to
loosen.
2. Lift hopper
straight up, off
frame.
Replacing Hopper
1. To replace hop-
per, position
drain over fitting
as far as it will
go, making sure
identification
label faces out.
2. Hand tighten fit-
ting.
8

Front Cover

Removing Cover
1. Remove hopper.
2. Unscrew
and remove
knob (S).
3. Place you
hand under
front, bot-
tom edge of
cover.
(3a) Lift
cover up,
(3b) then
pull bottom
toward you
and out to remove cover.
Replacing Cover
1. Place your
hand under
front, bottom
edge of
cover. (1a)
Position top
edge of
cover under
top metal lip
ti4503a
on sprayer
frame.
(1b) Then
push up on
cover so lower plastic edge of cover has room to
clear front metal frame and slide cover into place. To
position cover correctly, it will go in at an angle.
2. Replace knob (S). Hand tighten fitting.
3. Replace hopper.
ti4504a
3a
3b
S
ti4408a
1a
ti4411a
1b
ti4411a
S
310717E