Repair; Cover Removal; Voltage To Pressure Repair - Graco 26A010 Instructions Manual

Repair

Repair
Repair Repair
NOTE: In the following procedures, letters in
NOTE: NOTE:
parentheses refer to components with specific
purposes (see Components, page 9
in parentheses refer to find numbers for individual
parts (see Parts, page
The following diagram represents the electrical
connections between the primary components of the
integrated air control module.
Figure 5 Electrical Connections
Cover

Cover Removal

Cover Removal Removal
1. Loosen the four screws (31) securing the cover
(14) to the enclosure panel (15).
2. Tilt up the bottom of the cover and slide cover off
of the two upper screws to remove the cover.
18
) and numbers
22).
Voltage to to to Pressure Voltage Voltage Pressure Repair Pressure
The following instructions apply to both the Atomizing
Air (B) and Fan Air (C) V2P regulators. Verify which
regulator you are repairing or replacing before
removing.
1. Remove the cover
(see Cover Removal, page 18
2. Remove the split cable (39) on the regulator (1).
3. Remove the inlet (20) and outlet (35) fittings near
the base of the regulator.
4. Remove the screws (34) securing the regulator
bracket (2) to the enclosure panel (15).
5. Remove the V2P regulator (1) assembly.
6. Separate the regulator (1) from the regulator
bracket (2) by loosening the regulator bracket
screws at the bottom of the bracket.
7. Orient the new regulator (1) on the regulator
bracket (2) so that the inlet port (1 SUP) will face
the top of the enclosure and the outlet port (2
OUT) will face the bottom. Secure the regulator
to the regulator bracket with the four regulator
bracket screws.
8. Verify the orientation of the regulator (1)
assembly and attach it to the enclosure panel
(15) using the screws (34).
9. Attach the inlet (20) and outlet (35) fittings to the
regulator (1).
10. Attach the split cable (39) to the regulator (1).
11. Replace the cover.
Repair Repair
).
3A3465A