Table of Contents
Advertisement
2
Setup & Configuration
1. Client's Computer Setup
The computers on your LAN need to be set up to cooperate with MZK-04G
Wired Router.
Please make sure that your operating system already enabled your
interface card on the host and connected to one of the LAN ports on
MZK-04G through Cat.5 cable. Be sure that LEDs on MZK-04G
are already on and the LED corresponds with the port which you
connected. If you switch on MZK-04G for the first time, owing to
the default status, it will automatically enable the embedded DHCP
server and start to distribute IP to your host. In addition, the default
IP address of MZK-04G is "192.168.1.1." If your operating system is
Windows 98/2000/XP, you may be able to use command of "ipconfig"
to inquire whether you have the correct IP address or not. If you are
using Linux/Unix-Like system, you can use "ifconfig" to check your
NIC (Network Interface Card) address. The instructions are as follows:
Windows98
1. Click "Start Programs MS-DOS" or "Start Run..." and type
in "command.exe" and then press enter.
2. "MS-DOS" window will appear.
3. Type
4. MS-DOS will appear your NIC address in the window, please take
notice of the value of "IP Address" and "Default Gateway."
5. The value of "Default Gateway" is the IP address of MZK-04G.
after the command of "c:>" and then press enter.
Chapter 2 Basic Setup & Configuration
2
7
Advertisement
Table of Contents
