1998 Expedition/Navigator Workshop Manual
B12 CHECK CIRCUIT 682 (DB) FOR SHORT TO POWER
B13 CHECK THE FRONT AXLE ENGAGEMENT
B14 CHECK THE FRONT DRIVESHAFT ENGAGEMENT
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSWJ/~MUS~LEN/21/...
Is the resistance less than 5 ohms?
Yes
GO to B12.
No
REPLACE circuit 682 (DB). CLEAR the DTCs. TEST the system for normal operation.
Measure the voltage between mode switch C230-2, circuit 682 (DB), and ground.
Is any voltage indicated?
Yes
REPAIR circuit 682 (DB). CLEAR the DTCs. TEST the system for normal operation.
No
REPLACE the GEM; REFER to
Section
419-10. CLEAR the DTCs. TEST the system for normal operation.
Set the active commands AXLE ENGG to ON and AXLE DSCN to OFF.
Drive a short distance.
Raise and support the vehicle with the engine running; refer to
Spin one front tire. The other tire should spin in the opposite direction.
Is the axle working properly?
Yes
EXIT the active command mode and GO to
B14
No
LOWER the vehicle; GO to
Pinpoint Test
D.
Place the mode switch in the 4H position.
Section
100-02.
.
Page 22 of 64
8/30/2010