1998 Expedition/Navigator Workshop Manual
C38 CHECK CIRCUIT 764 (BR/W) TO THE CONTACT PLATE SWITCH C
C39 CHECK CIRCUIT 764 (BR/W) FOR SHORT TO GROUND
GEM C241
C40 CHECK CIRCUIT 764 (BR/W) FOR OPEN
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSWJ/~MUS~LEN/21/...
Does the PID PLATE_C not indicate OPEN?
Yes
GO to C39.
No
GO to C38.
Connect a jumper wire between transfer case assembly C201-9, circuit 764 (BR/W), and C201-10, circuit 762
(Y/W).
Monitor the PID PLATE_C.
Does the PID PLATE_C indicate CLOSED?
Yes
GO to C42.
No
GO to C40.
Measure the resistance between transfer case assembly C201-9, circuit 764 (BR/W), and ground.
Is the resistance greater than 10,000 ohms?
Yes
REPLACE the GEM; REFER to
Section
419-10. CLEAR the DTCs. TEST the system for normal operation.
No
REPAIR circuit 764 (BR/W). CLEAR the DTCs. CYCLE the ignition to OFF, then ON. TEST the system for normal
operation.
Measure the resistance between transfer case assembly C201-9, circuit 764 (BR/W), and GEM C241-19, circuit
764 (BR/W).
Page 51 of 64
8/30/2010