Advertisement
Vizualogic
DVD Headrest
"JK" Wrangler Installation Instructions
Figure 4
Driver
Side Cables
Figure 5
Hook Material
Figure 6
Figure 7
Seat Slider Rail
A/V Control
Module
Route Wires Below Seat Slider Rail
Page 3
A-1250™ & A-1150™
®
Passenger
Side Cables
Audio/Video
Module
Loop Material
For additional copies of these instructions please
visit our website for a downloadable PDF Version.
6. Route the Driver and Passenger side monitor cables as
shown. Use two cable zip ties to neatly bundle each set of
DVD cables where the cables exit the seat back and meet
the center console. Route the four monitor cables under-
neath the center console and exit the four cables at the
middle of the passenger side seat slider as shown.
(Figure 4)
7. Reconnect the upholstery channels on both front seats.
8. Adhere the rough "hook" side of the "hook and loop"
fastener material onto the floor carpet and under the front
passenger seat as shown.
9. Adhere the softer furry "loop" side of the "hook and
loop" fastener material onto Audio/Video Module as
(Figure 6)
shown.
10. Attach the FM Transmitter Antenna to the A/V Con-
trol Module and route underneath the seat slider and
under the center console. Extend the FM Transmitter An-
tenna towards the radio and underneath the center con-
sole.
11. Connect the monitor wires to the A/V Control Module
according to the Vizualogic installation manual. Again,
route all wires below the seat slider rails.
12. Connect the System Power Harness to the A/V Mod-
ule according to the Vizualogic installation manual. Once
again, route all wires below the seat slider rails. Use sev-
eral zip ties to neatly bundle the wires. Attach the A/V
Module underneath the front passenger seat with the
hook and loop fastener material.
(Figure 5)
(Figure 7)
www.quadratec.com
Advertisement
