Vizualogic ® A-1250™ & A-1150™ DVD Headrest “JK” Wrangler Installation Instructions Note: Be sure to read this entire instruction sheet AND the Vizualogic instruction sheet before beginning your installation. This sheet outlines the installation of a Vizualogic brand DVD Headrest Kit into a 2007 or newer Jeep Wrangler. These instructions are intended to assist with the installation process and by no means replace the Vizualogic installation manual.
Vizualogic A-1250™ & A-1150™ ® DVD Headrest “JK” Wrangler Installation Instructions For additional copies of these instructions please Figure 4 visit our website for a downloadable PDF Version. 6. Route the Driver and Passenger side monitor cables as shown. Use two cable zip ties to neatly bundle each set of DVD cables where the cables exit the seat back and meet Passenger Side Cables...
Vizualogic A-1250™ & A-1150™ ® DVD Headrest “JK” Wrangler Installation Instructions 13. Gently pry off the plastic Fascia Panel that’s in front of Figure 8 the gear shifter and just below the lower bank of switches as shown. A thin straight slot screwdriver works well. (Figure 8) Pry from the top corners only.
Vizualogic A-1250™ & A-1150™ ® DVD Headrest “JK” Wrangler Installation Instructions Figure 12 Power Outlet Plug 19. Disconnect the plug attached to the driver side power outlet. a. Attach a wire tap connector to the ( BLUE with PINK stripe) Yellow Harness Lift Dash wire at the Driver side Auxiliary Power Outlet plug.