Vizualogic HindSight Hummer Installation Manual

Monitor Installation

1. Locate the center console on the front part of the headliner.
2. Remove the (2) Phillips screws from the center console and slide
towards the front of the vehicle.
3. Insert the monitor cable through the opening in the headliner
and route to the A-pillar.
4. Pop out the (2) clips holding the handle to the driver side A-pillar.
(Fig.2)
5. Remove the handle and plastic shroud A-pillar.
6. Route the monitor cable from the headliner to the A/V Control
Module located under the seat or alternate location.
7. Insert the Monitor Cable into the opening on the backside of the
Monitor Housing.
8. Connect the Monitor Cable to the LCD Monitor.
9. Screw the LCD Monitor onto the Monitor Housing using the (2)
provided screws.
10. Secure the rear-hooks of the Monitor housing to the top of the
console. (Fig. 3)
Fig. 1
Backup Monitor System
Copyright © 2003 TMI Products, Inc.
All Rights Reserved
Corona, CA U.S.A.
1493 Bentley Drive • Corona, CA 92879 • 909-272-1996 • 800-624-7960 • Fax 909-272-1584
www.vizualogic.com
Fig. 2 Fig. 3
060300
99-8019-002
Backup Monitor System
LCD Monitor &
CCD Color Camera
Installation Manual
10/03
Hummer
H2–2003-2004
Fall 2003