Hws600/Hd - TDK-Lambada HWS?HWS User Manual

HWS
600/HD
HWS600/HD Specifications
ITEMS/UNITS
Voltage Range
Frequency
Power Factor (100/200VAC)(typ) (*2)
Input Efficiency (100/200VAC)(typ)
Current (100/200VAC)(typ)
Inrush Current (100/200VAC)(typ) (*4)
Leakage Current
Nominal Voltage
Maximum Current
Maximum Power
Maximum Line Regulation
Maximum Load Regulation
Output
Temperature Coefficient
Maximum Ripple & Noise (0<Ta<70 ) (*5) mVp-p
Maximum Ripple & Noise ( 10<Ta< 0 ) (*5) mVp-p
Hold-up Time (typ)
Voltage Adjustable Range
Over Current Protection
Over Voltage Protection
Remote Sensing
Remote ON/OFF Control
Function
Parallel Operation
Series Operation
Monitoring Signal
Line DIP
Operating Temperature
Storage Temperature
Operating Humidity
Storage Humidity
Environment
Vibration
Shock (In package)
Cooling
Withstand Voltage
Isolation
Isolation Resistance
Safety Standards
PFHC
Standards
EMI
Immunity
Weight (typ)
Mechanical
Size (W x H x D)
(*1) ( ): Peak output current at 200VAC. Operating time at peak output is less than 10sec, duty is less than 35%.
(*2) At 100/200VAC, Ta=25 and maximum output power.
(*3) For cases where conformance to various safety specs (UL, CSA, EN) are required,
to be described as 100 - 240VAC (50/60Hz).
(*4) Not applicable for the in-rush current to noise filter for less than 0.2ms.
Inrush Current is 30A (typ) when PFHC start-up.
(*5) Measure with JEITA RC-9131A probe, bandwidth of scope : 100MHz.
(*6) 85 - 265VAC, constant load.
(*7) No load - Full load, constant input voltage.
(*8) 3V and 5V model: Constant current limit and hiccup with automatic recovery.
12 - 48V model: Constant current limitwith automatic recovery.
Avoid to operate at over load or short circuit condition for more than 30 seconds.
(*9) OVP circuit will shut the output down, manual reset (CNT reset or Re-power on).
(*10) At 100/200VAC, nominal output voltage and maximum output current.
(*11) Measured by the each measuring method of UL, CSA, EN and DENAN (at 60Hz), Ta=25 .
(*12) Ratings - Derating at standard mounting. Refer to output derating curve.
- Load (%) is percent of maximum output power or maximum output current, whichever is greater.
(*13) For -40 to -10 need 3 minutes to stabilize the output voltage.
(*14) Category 4 exposure levels : Truck transportation over U.S. highways, composite two-wheeled trailer.
(*15) As for DENAN, designed to meet at 100VAC.
(Read instruction manual carefully, before using the power supply unit.)
MODEL
HWS600-3/HD HWS600-5/HD
(*3) V
(*3) Hz
(*2) 75 / 78
(*2) A 5.4 / 2.6
A
(*11) mA
VDC 3.3
(*1) A 120
W 396
(*6) mV 20
(*7) mV 30
120
180
(*10) ms
VDC 2.64-3.96
(*8) A >126
(*9) VDC 4.13-4.95
(*12)(*13) -10 to +71 (-10 to +50: 100%, +71: 50%) Guarantee start up at -40 to -10
RH
RH
At no operating, 10 - 55Hz (sweep for 1min) 19.6m/s² constant, X, Y, Z 1hour each.
(*14)
Less than 196.1m/s² Designed to meet MIL-STD-810F 516.5 Procedure I, VI
Output - FG : 500VAC (100mA),Output - CNT : 100VAC(100mA) for 1min
Approved by UL60950-1, CSA C22.2 No 60950-1, EN60950-1, EN50178
(*15)
Designed to meet IEC61000-4-2(Level 2,3), -3(Level 3), -4(Level 3),
g
mm
HWS600-12/HD HWS600-15/HD
AC85 - 265 or DC120 - 330
47 - 63
0.99 / 0.95
80 / 83
7.5 / 3.6
20 / 40
Less than 0.75. (0.2 (typ) at 100VAC / 0.44 (typ) at 230VAC)
5 12
53
600 636
48
72
Less than 0.02% /
20
4.0-6.0 9.6-14.4 12.0-18.0
>55.7
6.25-7.25 15.0-17.4 18.8-21.8
Possible
Possible
Possible
Possible
PF (Open Collector Output)
Designed to meet SEMI-F47 (200VAC Line only)
-40 to +85
10 - 90%RH (No dewdrop)
10 - 95%RH (No dewdrop)
Designed to meet MIL-STD-810F 514.5 Category 4, 10
Forced air by blower fan
Input - FG : 2.5kVAC (20mA), Input - Output : 3kVAC (20mA)
More than 100M Output - FG : 500VDC
More than 10M Output - CNT : 100VDC at 25
Designed to meet DENAN
Designed to meet IEC61000-3-2
Designed to meet EN55011/EN55022-B, FCC-B, VCCI-B
-5(Level 3,4), -6(Level 3), -8(Level 4), -11
1600
100 x 82 x 165 (Refer to outline drawing)
HWS600-24/HD HWS600-48/HD
81 / 84 82 / 85 83 / 86
8.1 / 3.9
15 24
43 27 (31)
645 648 624
60 96 192
90 144 288
150 350
200 400
19.2-28.8 38.4-52.8
>45.2 >31.4 >13.7
30.0-34.8 55.2-64.8
and 70%RH
48
13