Hws1000 - TDK-Lambada HWS?HWS User Manual

HWS
1000
HWS1000 Specifications
ITEMS/UNITS
Voltage Range
Frequency
Power Factor (100/200VAC)(typ) (*1)
Input Efficiency (100/200VAC)(typ)
Current (100/200VAC)(typ)
Inrush Current (100/200VAC)(typ) (*3)
Leakage Current (100/240VAC) (*10) mA
Nominal Voltage
Maximum Current
Maximum Peak Current
Maximum Power
Maximum Peak Power
Maximum Line Regulation
Output
Maximum Load Regulation
Temperature Coefficient
Maximum
Ripple & Noise (*4)
Hold-up Time (typ)
Voltage Adjustable Range
Over Current Protection
Over Voltage Protection
Remote Sensing
Remote ON/OFF Control
Function
Parallel Operation
Series Operation
Monitoring Signal
Line DIP
Operating Temperature
-10 to +40
Storage Temperature
Environment
Operating Humidity
Storage Humidity
Vibration
Shock (In package)
Cooling
Withstand Voltage
Isolation
Isolation Resistance
Safety Standards
PFHC
Standards EMI
Immunity
Weight (max)
Mechanical
Size (W x H x D)
(*1) At Ta=25 and maximum output power.
(*2) For cases where conformance to various safety specs (UL, CSA, EN) are required,
input voltage range will be 100 - 240VAC (50/60Hz).
(*3) First in-rush current. Not applicable to the first 0.2ms in-rush current flowing into the power supply noise filter.
(*4) Measure with JEITA RC-9131A probe, bandwidth of scope :100MHz.
At 100uF electric capacitor and 0.47uF film capacitor on the test fixture board.)
(*5) 85 - 265VAC, constant load.
(*6) No load-full load, constant input voltage.
(*7) Constant current limit with automatic recovery. Over current condition for more than 5 seconds will cause the
output to shutdown.
Output current exceeding maximum rated output current for more then 10 seconds continuously will result to
output shutdown.
(*8) OVP circuit will shut down output, manual reset (power cycle) or ON/OFF CNT signal reset.
(*9) At 100/200VAC, nominal output voltage and maximum output current.
(*10) Measured by the each measuring method of UL, CSA, EN and DENAN (at 60Hz), Ta=25 .
(*11) Ratings - Derating at standard mounting.
- Load (%) is percent of maximum output power or maximum output current, whichever is greater.
- As for other mountings, refer to derating curve.
(*12) As for DENAN, built to meet at 100VAC.
(*13) Peak output current is less than 10 seconds, and duty 35% max.(200VAC Line only)
(Read instruction manual carefully, before using the power supply unit.)
MODEL
(*2) V
(*2) Hz
(*1) 71 / 73 76 / 78
(*1) A 9.6 / 5.0
A
VDC 3.3 5
A 200
(*13) A
W 660 1000
(*13) W
(*5) mV 20
(*6) mV 40
0 to +71 C mVp-p 120
-10 to 0 C mVp-p 160
(*9) ms
VDC 2.64 - 3.96 4.0 - 6.0 4.8 - 7.2 6.0 - 9.0 9.6 - 14.4 12.0 - 18.0 19.2 - 28.8 28.8 - 43.2 38.4 - 52.8 48.0 - 66.0
(*7) A >210.0
(*8) VDC 4.12 - 4.62 6.25 - 7.0 7.5 - 8.4 9.37 - 10.5 15.0 - 17.4 18.7 - 21.8 30.0 - 34.8 45.0 - 49.7 55.2 - 60.0 69.0 - 75.0
(*11)
+50 83.9
+71
RH
RH
At no operating, 10 - 55Hz (sweep for 1min.) 19.6m/s² constant, X, Y, Z 1hour each.
Output-FG : 500VAC (300mA) (60V model 651VAC (390mA)), Output-CNT:100VAC (100mA) for 1min.
(*12) Approved by UL60950-1, CSA C22.2 No60950-1, EN60950-1,EN50178. Built to meet DENAN.
Built to meet EN55011/EN55022-B, FCC-ClassB, VCCI-ClassB, CISPR-ClassB.
g
mm
AC85 - 265 or DC120 - 330
47 - 63
0.98 / 0.95
79 / 81 80 / 82 82 / 85 83 / 85
13.5 / 7.0
20 / 40
1.2 max
6 7.5 12 15
167 134 88 70
160 100 80
1002 1005 1056 1050
1200
36 48 60
60 100 120
Less than 0.02%/
150
180
20
>175.3 >168.0 >105.0 >84.0
Possible
Possible
Possible
Possible
PF (Open collector output)
Built to meet SEMI-F47 (200VAC line only)
-10 to +71 , start up -20 to +71
100
50
-30 to +85
10 - 90 (No Condensing)
10 - 95 (No Condensing)
Less than 196.1m/s²
Forced air by blower fan
Input - FG : 2kVAC (20mA), Input - Output : 3kVAC (20mA)
More than 100M Output - FG : 500VDC
More than 10M Output - CNT 100VDC at 25
Built to meet IEC61000-3-2
Built to meet IEC61000-4-2(Level 2,3), -3(Level 3), -4(Level 3),
-5(Level 3,4), -6(Level 3), -8(Level 4), -11
3200
126.5 x 82 x 240 (Refer to outline drawing)
85 / 87 85 / 88 86 / 88 85 / 88
24 36 48
46 30.7 23 18.4
58.5 39 29.2 23.4
1104
1404
96 144 192 240
150 300 360
200 400
240 500 600
>61.4 >40.9 >30.6 >24.5
100
and 70%RH
60