Hws1500 - TDK-Lambada HWS?HWS User Manual

HWS
1500
HWS1500 Specifications
ITEMS/UNITS
Voltage Range
Frequency
Power Factor (100/230VAC)(typ) (*1)
Input Efficiency (100/200VAC)(typ)
Current (100/200VAC)(typ)
Inrush Current (100/200VAC)(typ) (*3)
Leakage Current (100/240VAC) (*10) mA
Nominal Voltage
Maximum Current (100/200VAC)
Maximum Peak Current
Maximum Power (100/200VAC)
Maximum Peak Power
Maximum Line Regulation
Output Maximum Load Regulation
Temperature Coefficient
+25 to +70
Maximum
Ripple & Noise (*4)
Hold-up Time (typ)
Voltage Adjustable Range
Over Current Protection
Over Voltage Protection
Remote Sensing
Remote ON/OFF Control
Function
Parallel Operation
Series Operation
Monitoring Signal
Line DIP
Operating Temperature
-10 to +40°C
at Input Voltage
100VAC/200VAC
Environment Storage Temperature
Operating Humidity
Storage Humidity
Vibration
Shock (In package)
Cooling
Withstand Voltage
Isolation
Isolation Resistance
Safety Standards
PFHC
Standards
EMI
Immunity
Weight (typ)
Mechanical
Size (W x H x D)
(*1) At Ta=25 and maximum output power.
(*2) For cases where conformance to various safety specs (UL, CSA, EN) are required, input voltage range will be 100 - 240VAC (50/60Hz).
(*3) First in-rush current. Not applicable to the first 0.2ms in-rush current flowing into the power supply noise filter.
(*4) Measure with JEITA RC-9131A probe, bandwidth of scope: 100MHz.
(at 100uF electric capacitor and 0.47uF film capacitor on the test fixture board.)
Ripple noise spec for ambient temperature between -10 to 25 is a linearity value with respect to the -10 degrees
C and 25 degrees C specs.
(*5) 85 - 265VAC, constant load.
(*6) No load-Full load, constant input voltage.
(*7) Constant current limit with automatic recovery. Over current condition for more than 5 seconds will cause the out-
put to shutdown. Output current exceeding maximum rated output current for more then 10 seconds continuously
will result to output shutdown.
(*8) OVP circuit will shut down output, manual reset (power cycle) or ON/OFF CNT signal reset.
(*9) At 100/200VAC, nominal output voltage and maximum output current.
(*10) Measured by the each measuring method of UL, CSA, EN and DENAN (at 60Hz), Ta=25 .
(*11) Ratings - Derating at standard mounting.
- Load (%) is percent of maximum output power or maximum output current, whichever is greater.
- As for other mountings, refer to derating curve.
(*12) As for DENAN, built to meet at 100VAC.
(*13) Peak output current is less than 10 seconds, and duty 35% max. (200VAC Line only)
(Read instruction manual carefully, before using the power supply unit.)
MODEL HWS1500

HWS1500

HWS1500
-3 -5
(*2) V
(*2) Hz
(*1) 72 / 75 77 / 81 79 / 82
(*1) A 15.0 / 8.0 19.5 / 10.0
A
VDC 3.3 5
A 300 / 300 250 / 250 200 / 200 125 / 125 100 / 100
(*13) A
W 990 / 990
(*13) W
(*5) mV 36
(*6) mV 60
mVp-p
0 mVp-p 200
-10 mVp-p 220
(*9) ms 20
VDC 2.64 - 3.96 4.0 - 6.0 4.8 - 7.2
(*7) A >315.0 >262.5
(*8) VDC 4.12 - 4.62 6.25 - 7.0 7.5 - 8.4
(*11)
W 990
+50°C W 825 1250
+60°C W 660 1000
+70°C W 495
RH
RH
At no operating, 10 - 55Hz (sweep for 1min.) 19.6m/s² constant, X, Y, Z 1hour each.
Input - FG : 2kVAC (20mA), Input - Output : 3kVAC (20mA), Output - CNT : 100VAC (100mA)
Output - FG : 500VAC (300mA), (60V model 651VAC (390mA) ) for 1min.
More than 100M Output - FG : 500VDC More than 10M
(*12) Approved by UL60950-1, CSA C22.2 No.60950-1, EN60950-1, EN50178. Built to meet DENAN.
Built to meet EN55011/EN55022-A, FCC-ClassA, VCCI-ClassA.
Built to meet IEC61000-4-2(Level 2,3), -3(Level 3), -4(Level 3), -5(Level 3,4), -6(Level 3), -8(Level 4), -11
g 4000
mm
HWS1500 HWS1500 HWS1500
-6 -7 -12 -15
AC85 - 265 or DC120 - 330
47 - 63
0.98 / 0.94
81 / 83 82 / 85 83 / 87
20 / 40
1.5 max
6 7.5 12 15
300 240
1500 / 1500
1800
40 48 60
72 90
Less than 0.02%/
150
150
200
16
6.0 - 9.0 9.6 - 14.4 12.0 - 18.0 19.2 - 28.8 28.8 - 43.2 38.4 - 52.8 48.0 - 66.0
>210.0 >131.2 >105.0
9.37 - 10.5 15.0 - 17.4 18.7 - 21.8 30.0 - 34.8 45.0 - 49.7 55.2 - 64.8 69.0 - 75.0
Possible
Possible
Possible
Possible
PF (Open collector output)
Built to meet SEMI-F47 (200VAC Line only)
-10 to +70, start up -20 to +70
1500
1500
1125
750
-30 to +85
10 - 90 (No Condensing)
10 - 95 (No Condensing)
Less than 196.1m/s²
Forced air by blower fan
Output - CNT 100VDC at 25
Built to meet IEC61000-3-2
126.5 x 82 x 280 (Refer to outline drawing)
HWS1500 HWS1500 HWS1500 HWS1500
-24 -36 -48 -60
84 / 88 86 / 90
19.0 / 10.0
24 36 48 60
65 / 70 42 / 46.5 32 / 32 25.6 / 28
105 70 42
1560 / 1680 1512 / 1674 1536 / 1536 1536 / 1680
2520 2520
96 144 192 240
144 150 288 360
200 400
200 400
240 400 600
20
>68.2 >44.1 >33.6 >26.8
1560 / 1680 1512 / 1674 1536 1536 / 1680
1560 / 1680 1512 / 1674 1536 1536 / 1680
1170 / 1260 1134 / 1255 1152 1152 / 1260
780 / 840 756 / 837 768 768 / 840
and 70%RH
3800