Connecting A Vcr And Antenna Or Cable Tv (No Cable Box) - Toshiba 26HL37 Owner's Manual

267470726HL37_EN.book Page 11 Friday, July 6, 2007 7:44 PM

Connecting a VCR and antenna or Cable TV (no Cable box)

TV upper back panel
TV lower back panel
You will need:
coaxial cables
•
standard A/V cables
•
– For better picture performance, if your VCR has S-video,
connect an S-video cable and standard (analog) audio
cables to the VIDEO-2 inputs on the side panel (instead of
the VIDEO-1 inputs). Do not connect both types of video
cable to VIDEO-2 at the same time or the picture
performance will be unacceptable.
– If you have a mono VCR, connect L/MONO on the TV to
your VCR's audio out terminal using the white audio cable
only.
Chapter 2: Connecting your TV
Stereo VCR
To view the antenna or Cable signal:
Select the ANT video input source on the TV.*
To view the VCR:
Turn ON the VCR. Select the Video1 video input source on
the TV.*
* To select the video input source, press INPUT on the remote control
(- page 30). To program the TV remote control to operate other
devices, see Chapter 3.
The unauthorized recording, use, distribution, or revision of
television programs, videotapes, DVDs, and other materials is
prohibited under the Copyright Laws of the United States and
other countries, and may subject you to civil and criminal
liability.
From Cable TV or antenna
VIDEO AUDIO
L R
IN IN from ANT
CH 3
CH 4
OUT
OUT to TV
L R
HL37 (E/F) Web 213:276
11