Adjusting The Picture; Selecting The Picture Mode; Adjusting The Picture Quality - Toshiba 26HL37 Owner's Manual

267470726HL37_EN.book Page 35 Friday, July 6, 2007 7:44 PM

Adjusting the picture

Selecting the picture mode

You can select your desired picture settings from four different
modes, as described below.
Mode Picture Quality
Sports Bright and dynamic picture (factory setting)
Standard Standard picture settings (factory setting)
Lower contrast for darkened room (factory
Movie
setting)
Preference Your personal preferences
To select the picture mode:
Press u on the remote control.
The following popup menu appears on-screen.
Standard
Repeatedly press u to cycle among the modes or use C or
c to select the modes.
To select the picture mode using the menu system:
1
Press Y and open the Picture menu.
2
Press B or b to highlight Mode.
Mode
Picture Settings
Cinema Mode
MENU EXIT
Back
3
Press C or c to select the mode you prefer.
Note:
• The picture mode you select affects the current input
only. You can select a different picture mode for each
input.
• If you select one of the factory-set picture modes
(Sports, Standard, or Movie) and then change a
picture quality setting (for example, increase the
contrast or change the color temperature), the picture
mode automatically changes to Preference in the
Picture menu.
Chapter 6: Using the TV's features
Picture
Sports
ENTER
Video
Exit

Adjusting the picture quality

You can adjust the picture quality (back light, contrast,
brightness, color, tint, and sharpness) to your personal
preferences.
Pressing C
Selection
Back Light darker
Contrast lower
Brightness darker
Color paler
Tint reddish
Sharpness softer
To adjust the picture quality:
1
Press Y and open the Picture menu.
2
Highlight Picture Settings and press T.
3
Press B or b to select the picture quality you want to
adjust (Back Light, Contrast, Brightness, Color,
Tint, or Sharpness), and then press C or c to adjust the
setting, as described in the table above.
Picture Settings
Back Light
Contrast
Brightness
Color
Tint
Sharpness
MENU Back EXIT Exit
Contrast
The picture qualities you adjusted are automatically saved in
the Preference mode (- "Selecting the picture mode,"
above left).
Note:
• The cold cathode fluorescent lamp used for the back light
on this TV has a limited life. When areas on the screen
darken, flicker, or no longer light up, the lamp may be at the
end of its life.
• When the TV is in VIDEO mode or when no signal is
received, the back light feature is automatically set to "0"
(zero).
Pressing c
lighter
higher
lighter
deeper
greenish
sharper
1/2
100
100
50
50
0
0
80
35
HL37 (E/F) Web 213:276