Chapter 5: Setting Up Your Tv; Selecting The Menu Language; Programming Channels Into The Tv's Channel Memory; Programming Channels Automatically - Toshiba 26HL37 Owner's Manual

267470726HL37_EN.book Page 26 Friday, July 6, 2007 7:44 PM

Selecting the menu language

You can choose from three different languages (English,
French and Spanish) for the on-screen display of menus and
messages.
To select the menu language:
1
Press Y and open the Set Up menu.
2
Press B or b to highlight Language.
Language
TV/CABLE
CH Program
Add/Erase
Channel Labeling
Video Label
MENU Back EXIT
3
Press C or c to display your desired language.
4
Press O to close the Set Up menu.
26

Chapter 5: Setting up your TV

Set Up 1/2
English
TV
ENTER
Add
ENTER
Exit
Programming channels into the
TV's channel memory
When you press < or , on the remote control or TV control
panel, your TV will stop only on the channels you program into
the TV's channel memory.
Follow the steps below to program channels into the TV's
channel memory.

Programming channels automatically

Your TV can automatically detect all active channels in your
area and store them in its memory. After the channels are
programmed automatically, you can manually add or erase
individual channels in the channel memory.
Note:
• If the input signal type is set to CABLE for an antenna input,
the automatic channel programming process erases
channels that were previously programmed into the TV's
memory.
• If the input signal type is set to TV, the automatic channel
programming process does NOT erase channels that were
previously programmed into the TV's memory, but adds
newly found channels to the existing set of programmed
channels. To remove a channel from the memory, you must
manually delete it.
• To tune the TV to a channel not programmed in the channel
memory, you must use the Channel Number buttons on the
remote control.
• Programming channels for an antenna input configured for
CABLE will take substantially longer than for an antenna
input configured for TV. This is normal; however, once
channel programming is completed, you should not have to
repeat the programming process again unless your Cable
TV service lineup changes significantly.
To program channels automatically:
1
Press Y and open the Set Up menu.
2
Press B or b to highlight TV/CABLE.
3
Press C or c to select either TV (if you use an antenna) or
CABLE (if you use cable channels).
Set Up
Language
TV/CABLE
CH Program
Add/Erase
Channel Labeling
Video Label
MENU Back EXIT Exit
1/2
English
CABLE
ENTER
Add
ENTER
HL37 (E/F) Web 213:276