Table Of Contents - TDK-Lambda Genesys Series User Manual

1. THE DIGITAL (IEEE 488.2 SCPI) PROGRAMMING OPTION ..................................1
1.1 INTRODUCTION ...........................................................................................................................................1
1.2 SCOPE OF MANUAL .....................................................................................................................................1
1.3 CONFIGURATION .........................................................................................................................................1
1.4 GLOSSARY ......................................................................................................................................................1
1.5 USING DIGITAL PROGRAMMING ...........................................................................................................2
1.5.1 THE IEEE-488.2 INTERFACE
1.6 POINT-TO-POINT MODE vs MULTI DROP MODE ................................................................................2
1.7 CONFIGURING THE IEEE INTERFACE ..................................................................................................3
1.7.1 SETTING THE POWER SUPPLY AND IEEE SELECT SWITCH
1.7.2 CONFIGURING THE IEEE CONTROLLER
1.8 CONFIGURING THE SUPPLIES.................................................................................................................4
1.9 THE INTERFACE INPUT BUFFER ............................................................................................................4
1.10 GETTING STARTED WITH THE SOFTWARE ....................................................................................4
1.10.1 EXAMPLE SESSION USING THE 'IBIC' CONSOLE
1.10.2 EXAMPLE PROGRAM WRITTEN IN VISUAL BASIC
1.10.3 EXAMPLE PROGRAM WRITTEN IN LABVIEW
2. PROGRAMMING COMMANDS ................................................................................7
2.1 COMMAND NOTES .......................................................................................................................................7
2.2 PROGRAMMING AND MESUREMENT COMMANDS ..........................................................................7
2.2.1 PROGRAM OUTPUT VOLTAGE
2.2.2 READ PROGRAMMED VOLTAGE COMMAND
2.2.3 MEASURE VOLTAGE COMMAND
2.2.4 PROGRAM OUTPUT CURRENT COMMAND
2.2.5 READ PROGRAMMED CURRENT COMMAND
2.2.6 MEASURE CURRENT COMMAND
2.2.7 ENABLE THE SUPPLY OUTPUT COMMAND
2.2.8 DISABLE THE SUPPLY OUTPUT COMMAND
2.2.9 READ OUTPUT ENABLE COMMAND
2.2.10 GO TO LOCAL MODE COMMAND
2.2.11 GO TO REMOTE MODE COMMAND
2.2.12 GO TO REMOTE WITH LOCAL LOCK OUT COMMAND
2.2.13 READ PROGRAMMING MODE COMMAND
2.3 GLOBAL OUTPUT COMMANDS .............................................................................................................10
2.3.1 USAGE
2.3.2 GLOBAL PROGRAM OUTPUT VOLTAGE
2.3.3 GLOBAL PROGRAM OUTPUT CURRENT
2.3.4 GLOBAL EANBLE THE SUPPLY OUTPUT COMMAND

Table of Contents

2
3
3
4
5
6
7
8
8
8
8
9
9
9
9
9
10
10
10
10
11
11
11