Table of Contents
Advertisement
Connecting an Aerial (For analogue and Digital signals)
To view television channels correctly, a signal must be received by the set from the following source:
-An outdoor VHF/UHF antenna
Connecting External A/V Devices
-Connect a Video RCA or S-VIDEO cable to an appropriate external A/V device such as a VCR, DVD or Camcorder.
- Connect RCA audio cables to "R -AUDIO - L" on the rear of your set and the other ends to corresponding
audio out connectors on the A/V device.
RS232
-Connector for service ONLY (do not connect any equipment here.)
Connecting Component Devices (DVD/PVR)
-Connect Component video and audio cables to Component inputs ("P
the other ends to corresponding component video out connectors on the PVR or DVD.
-The Y, P
/C
and PR/CR" connectors on your component devices (PVR or DVD) are sometimes labeled Y, B-Y
B
B
and R-Y or Y, C
and C
. (Colors for inputs and cables must correspond to both devices.)
B
R
NOTE: Some devices such as a PVR or DVD players require 'Component/YP
settings - please consult your device user manual for instructions.
Connecting HDMI
-Supports digital connections between HDMI - enabled AV devices such as (PVRs, DVD, BluRay, HDDVD, AV receivers and
digital devices.). -No sound connection is needed for an HDMI to HDMI connection.
NOTE: Some devices such as a PVR or DVD players require a HDMI signal to be set via the output in the device's settings -
please consult your device user manual for instructions.
/C
", "P
/C
", "Y") on the rear of your set and
R
R
B
B
'signal to be set via output in the devices
P
B
R
10
Hide quick links:
Advertisement
Table of Contents
