Optional Trapeze Support Installation - Basic American Zenith 7000 Instructions For Use And Service Manual

OPTIONAL TRAPEZE SUPPORT INSTALLATION

(The Trapeze Support it attached to the head section of the bed)
Use third hole
from the end of the
main frame tubes
1. Begin by removing the headboard panel assembly (#2),
if previously assembled to the bed, by pulling out the
two Clevis Pins and two Hair Pin Clips that attach the
main frame tubes to the headboard's mounting tubes.
Set all pins aside for later use.
2. Detach the headboard panel from the mounting tubes
by unscrewing the four 40mm Allen Head Bolts that
hold the board to the tubes (These will be replaced
with the longer Phillips Head Pan Screws from your
trapeze adaptor hardware bag.) Do not remove the
four 1/4-20 inserts (#3) from the board. They will be
used again to mount the board to the trapeze support.
3. Assemble the Trapeze Support (#1) to the main frame
tubes using the two Clevis Pins and Hair Pin clips you
removed in Step 1. The first holes in the Trapeze tubes
must line up with the third hole from the end in the main
frame tubes as shown.
Basic American Medical Products, a division of GF Health Products, Inc.
Please order Kit Number ZA79000
4. Insert the 1/4-20 x 2.50" Carriage Bolt (#5) into the vertical
support as shown and fasten with a 1/4-20 Hex head Lock
Nut (#6). Both parts should be in your hardware bag.
5. Assemble the headboard to the inside of the Trapeze
Support so that the side of the headboard with the inserts
is facing away from the Trapeze Support. From the outside,
insert the four 1/4-20 x 1.75" long Machine Screws (#4)
from your hardware bag through the holes in the Trapeze
Support, screwing them into the inserts in the headboard.
6. OPTIONAL—FOR TMI TRAPEZE BAR WITH SLEEVE:
Insert the Sleeve into the vertical support with the slot on
the bottom. Rotate the sleeve unitl it falls into place over the
carriage bolt you inserted in Step 4. This will lock it into
the proper position. (Note: Top of the Sleeve should sit
flush with the top of the vertical support on the Trapeze
Support Adaptor.)
www.grahamfield.com
ZENITH SERIES
Trapeze Support
vertical support
tube. (TMI Bar
Sleeve would be
inserted inside
the tube.)
Use first holes in
Trapeze Support
to mount to main
frame tubes.
18
999-0843-190A Service Manual