Table of Contents
Advertisement
STANDARD MATTRESS RETAINER INSTALLATION & POSITIONS
(IMPORTANT: MUST MATCH HEAD/FOOTBOARD AND WALLSAVER POSITIONING)
1. HEAD RETAINER INSTALLATION
• Position retainer with curved end toward headboard.
• Squeeze ends of the retainer toward the inside of
the bed and lower between the head deck rails and
first outside grid wires.
• Align the ends of retainer with small holes on the
inside of deck rails and slowly release. The bottom
angle of the retainers will rest on top of the deck.
cLoSeUp oF 80"
Foot retaIner
poSItIon In Foot DecK
3. RETAINER POSITIONS
• FOR 80" BEDS: Use outside small holes.
See sample at right.
• FOR 76" BEDS: Use inside small holes.
See sample at right.
USE LOCATION STICKER ON
TOP, RIGHT SIDE OF HEAD
& FOOT DECKS AS A GUIDE
ALL POSITIONS OF BOARDS,
WALLSAVERS, AND RETAINERS
MUST MATCH FOR PROPER BED OPERATION.
Be sure to use a mattress that is properly sized to fit
the sleep deck, which will remain centered on the
deck relative to State and Federal Guidelines. Use
of an improperly fitted mattress could result in injury
or death.
Basic American Medical Products, a division of GF Health Products, Inc.
• Position retainer with curved end toward footboard.
• Squeeze ends of the retainer toward the inside of
the bed and lower between the foot deck rails and
first outside grid wires.
• Align the ends of retainer with small holes on the
inside of deck rails and slowly release. The bottom
angle of the retainers will rest on top of the deck.
80" 76"
www.grahamfield.com
cLoSeUp oF 80"
HeaD retaIner
poSItIon In HeaD DecK
2. FOOT-END RETAINER INSTALLATION
Use a properly sized mattress in order to minimize
the gap between the side of the mattress and assist
devices. This gap must be small enough to prevent
resident/patient from getting his/her head or neck
caught in this location.
ZENITH SERIES
11
999-0843-190A Service Manual
Advertisement
Table of Contents
Troubleshooting
