Table of Contents
Advertisement
OPTIONAL PLASTIC HALF RAIL INSTALLATION & OPERATION
(Sample shows rail positioned on right side of bed)
1. Position the Plastic Half Rail (#2) as shown, with the taller, straight edge
toward the head end of the bed and arms angled toward center of the bed.
2. From the outside, insert the two welded pins (with grooves) on the
rail arms into the two large holes in the side of the head deck.
3. From the inside, insert the metal hair pin clip end of the
Lanyard Assembly (#3) onto the exposed grooves
at the ends of the clevis pins.
4. Position the other terminal ends of the lanyard
assemblies (#3) over the small hole on the inside
of the deck frame. Secure with a small
threaded Phillips Screw (#4).
PLEASE ORDER PLASTIC RAIL KIT #ZA84200,
WHICH INCLUDES A RIGHT-HAND AND LEFT-
HAND HALF RAIL, FOUR LANYARD ASSEMBLIES,
AND TWO PHILLIPS SCREWS. ORDER BAG
#999-0842-905 FOR JUST THE REPLACEMENT
HARDWARE.
THE PLASTIC RAIL CAN BE POSITIONED ON
EITHER THE HEAD OR FOOT DECKS FOR 80"
BEDS. THEY SHOULD ONLY BE PUT ON THE
HEAD END FOR 76" BEDS.
PLASTIC HALF RAIL OPERATION
11.50"
(292 mm)
15.75"
(400 mm)
SLEEP
SURFACE
Press Release
Lever to Lower
Make sure the rail is always in its "Full Up
Locked" position when leaving the resident/
patient unattended to avoid possible injury.
Basic American Medical Products, a division of GF Health Products, Inc.
FULL UP LOCKED
POSITION ON 80" BED
Head Deck (#1)
Lanyard
Assembly (#3)
Phillips
Screw (#4)
7.00"
(178 mm)
To avoid pinching of fingers, hold the half rail
from the top with one hand and carefully depress
the release lever with the other. Make sure there
are no objects in the way that may hinder the full
movement of the rail.
www.grahamfield.com
ZENITH SERIES
Plastic Half Rail
Assembly (#2)
Small
Hole
Lanyard
Assembly (#3)
HEAD END
FULL DOWN UNLOCKED
POSITION ON 80" BED
SLEEP
SURFACE
Press Release
Lever to Raise
999-0843-190A Service Manual
Straight Edge
toward Head End
17
Advertisement
Table of Contents
Troubleshooting
