Standard Wireform Wallsaver Installation; Wallsaver Assembly - Basic American Zenith 7000 Instructions For Use And Service Manual

STANDARD WIREFORM WALLSAVER INSTALLATION

STEP 1: WALLSAVER ASSEMBLY
1. Position the Wireform Wallsaver (part # 999-0844-180) with bend
end facing upward and tab ends facing inward as shown at right.
2. Determine the position desired (See Bottom of page).
3. Gently squeeze the tab ends of the wallsaver inward toward the
center of the wallsaver and, holding the tabs parallel with the slots
in the caster bases (See DETAIL A), slide the tabs into the slots
while letting the wallsaver gently expand outward.
4. Turn the wallsaver downward until it rests on the floor (See Detail B)
STEP 3: WALLSAVER
POSITIONS
1. The Zenith 7000 Wallsaver features
three positions for easy reconfiguration
- 76", 80", and Trapeze
2. For 76" beds, position the wallsaver
ends in the caster base slots closest
to the FOOT end of the bed.
3. For 80" beds, position the wallsaver
ends in the MIDDLE slots on the
caster bases.
4. If you have an optional Trapeze unit
on a 76" bed, position the wallsaver
ends in the MIDDLE slots on the
caster bases. For 80" beds position
wallsaver in slots closest to the HEAD.
Basic American Medical Products, a division of GF Health Products, Inc.
76" Bed Wallsaver
Position w/o Trapeze
www.grahamfield.com
STEP 2: WALLSAVER
1. To remove or move the Wireform
Wallsaver to a new position, raise
the wallsaver off the floor until
the end tabs are horizontal.
2. Squeeze the ends toward the
center of the wallsaver until the
end tabs slide out of the caster
base slots.
76" Bed Wallsaver
Position w/ Trapeze or
80" Bed w/oTrapeze
ZENITH SERIES
REMOVAL
80" Bed Wallsaver
Position w/ Trapeze
12
999-0843-190A Service Manual