Checking And Charging The Battery - Yamaha MT-01 T 2005 Service Manual

cal system, cause the lighting and ignition
systems to malfunction and could possibly
cause a fire.
L LLL L LLL L L LLL L
4. Install:
• Lead holder
• Seat
Refer to "GENERAL CHASSIS" on page 4-1.
EAS28030

CHECKING AND CHARGING THE BATTERY

EWA13290
WARNING
Batteries generate explosive hydrogen gas
and contain electrolyte which is made of poi-
sonous and highly caustic sulfuric acid.
Therefore, always follow these preventive
measures:
• Wear protective eye gear when handling or
working near batteries.
• Charge batteries in a well-ventilated area.
• Keep batteries away from fire, sparks or
open flames (e.g., welding equipment,
lighted cigarettes).
• DO NOT SMOKE when charging or han-
dling batteries.
• KEEP BATTERIES AND ELECTROLYTE
OUT OF REACH OF CHILDREN.
• Avoid bodily contact with electrolyte as it
can cause severe burns or permanent eye
injury.
FIRST AID IN CASE OF BODILY CONTACT:
EXTERNAL
• Skin — Wash with water.
• Eyes — Flush with water for 15 minutes and
get immediate medical attention.
INTERNAL
• Drink large quantities of water or milk fol-
lowed with milk of magnesia, beaten egg or
vegetable oil. Get immediate medical atten-
tion.
ECA13660
CAUTION:
• This is a sealed battery. Never remove the
sealing caps because the balance between
cells will not be maintained and battery per-
formance will deteriorate.
• Charging time, charging amperage and
charging voltage for an MF battery are dif-
ferent from those of conventional batteries.
The MF battery should be charged as ex-
plained in the charging method illustra-
tions. If the battery is overcharged, the
L LLL L L LLL L L LLL L
ELECTRICAL COMPONENTS
electrolyte level will drop considerably.
Therefore, take special care when charging
the battery.
LLL
NOTE:
Since MF batteries are sealed, it is not possible
to check the charge state of the battery by mea-
suring the specific gravity of the electrolyte.
Therefore, the charge of the battery has to be
checked by measuring the voltage at the battery
terminals.
1. Remove:
• Seat
Refer to "GENERAL CHASSIS" on page 4-1.
2. Disconnect:
• Battery leads
(from the battery terminals)
ECA13640
CAUTION:
First, disconnect the negative battery lead
"1", and then positive battery lead "2".
3. Remove:
• Battery band
• Battery
4. Check:
• Battery charge
M MMM M MMM M
a. Connect a pocket tester to the battery termi-
nals.
• Positive tester probe →
positive battery terminal
• Negative tester probe →
negative battery terminal
NOTE:
• The charge state of an MF battery can be
checked by measuring its open-circuit voltage
(i.e., the voltage when the positive battery ter-
minal is disconnected).
• No charging is necessary when the open-cir-
cuit voltage equals or exceeds 12.8 V.
7-94
2
1
M MMM M M MMM M M MMM M M MMM M MMM