Checking The Valve Seats - Yamaha MT-01 T 2005 Service Manual

6. Measure:
• Valve stem runout
Out of specification → Replace the valve.
NOTE:
• When installing a new valve, always replace
the valve guide.
• If the valve is removed or replaced, always re-
place the oil seal.
Valve stem runout
0.010 mm (0.0004 in)
EAS24300

CHECKING THE VALVE SEATS

The following procedure applies to all of the
valves and valve seats.
1. Eliminate:
• Carbon deposits
(from the valve face and valve seat)
2. Check:
• Valve seat
Pitting/wear → Replace the cylinder head.
3. Measure:
• Valve seat width C "a"
Out of specification → Replace the cylinder
head.
VALVES AND VALVE SPRINGS
Valve seat width C (intake)
0.90–1.10 mm (0.0354–0.0433 in)
Limit
2.0 mm (0.08 in)
Valve seat width C (exhaust)
0.90–1.10 mm (0.0354–0.0433 in)
Limit
2.0 mm (0.08 in)
M MMM M MMM M M MMM
a. Apply Mechanic's blueing dye (Dykem) "b"
onto the valve face.
b. Install the valve into the cylinder head.
c. Press the valve through the valve guide and
onto the valve seat to make a clear impres-
sion.
d. Measure the valve seat width.
NOTE:
Where the valve seat and valve face contacted
one another, the blueing will have been re-
moved.
L LLL L LLL L L LLL
4. Lap:
• Valve face
• Valve seat
NOTE:
After replacing the cylinder head or replacing the
valve and valve guide, the valve seat and valve
face should be lapped.
5-37
M M MMM M M MMM M
L L LLL L L LLL L
M MMM M MMM
L LLL L LLL