Installation - Superior BRT4036TMN Installation And Operation Instructions Manual

WALL SWITCH INSTALLATION
The installation of a wall switch allows you to activate the gas control valve without normal
household electricity since valve operates on millivolt current supplied by heat generated by
the thermopile. To install wall switch:
1. Remove front refractory access panel by lifting up and angling out of firebox opening (see
Figure 13).
2. Use wire and connectors provided. Attach red wire to terminal marked TH/TP on control
valve. Attach white wire to blade connector on open end of safety circuit wiring (see Wiring
Diagram, page 22).
Note: If any of the original wire from unit control must be replaced, use the same type or a
higher rated wire (25 ft. maximum length).
WARNING: Do not wire re-
mote wall switch to main power
supply (Standard 120v house-
hold current).
3. Locate wall switch in a convenient location.
4. After wire connections are complete,
replace refractory access panel.
INSTALLING WIRELESS HAND-HELD REMOTE CONTROL MRC SERIES
Note: If using optional wireless hand-held remote control, the wall switch is no longer operational.
Installing Receiver
1. Remove front refractory access panel by lifting up and angling out of firebox opening (see
Figure 13) to expose controls.
2. Disconnect wall switch wires from TH and TH/TP terminals on control valve (see Figure 14).
3. See remote instructions for further information.
Note: If any of the original wire as
supplied must be replaced, use 18
AWG TYPE CL2 (UL) 105 C (25 ft.
length MAXIMUM) or equivalent.
12

INSTALLATION

To Safety Circuit
Figure 14 - Wall Switch Wiring Diagram
www.SuperiorFireplaces.US.com
Figure 13 - Removing Front Refractory
Access Panel
Route Millivolt
Wires (Supplied)
Through Gas Line
Conduit Sleeve
To Thermopile
Wall Switch
(Not Supplied)
(Back View)
126736-01B