Superior BRT4036TMN Installation And Operation Instructions Manual page 17

COMBUSTION AIR KIT MODEL AK4
(OPTIONAL)
The outside air kit may be installed on the left
side of fireplace only. The vent can be installed
through any outside wall a minimum of three
feet below fireplace termination cap. The
handle to operate damper door for outside
air inlet will be located inside the left "screen
pocket" of firebox (see Figure 30). Pull handle
to open or push to close.
CAUTION: Air inlet ducts are
not to terminate in attic space.
Air Kit
Handle
Figure 30 - Air Kit Handle Location
APPLIANCE ENCLOSURE
Before finishing enclosure around appliance,
inspect all joints around outer surround. Any
gaps between nailing flanges and framing
should be sealed with noncombustible insula-
tion or caulking.
If appliance is mounted on a raised platform,
it must be a continuous surface and not
on blocks without a solid surface. This will
prevent the entry of cold air by means of con-
duction through the total bottom of appliance
(see Figure 31).
Side
Framing
Caulk Here
Figure 31 - Sealing Between Appliance
and Framing
126736-01B
INSTALLATION
Continued
Screen
Pocket
Side
Framing
Pack Insulation
www.SuperiorFireplaces.US.com
INSTALLING OPTIONAL GLASS
DOOR ACCESSORY
CAUTION: Use only glass
doors certified for use with this
appliance.
Note: Glass door may be heavy for some
individuals. Please request help if needed.
The BRT4036, BRT4336, BRT4536, BRT4042,
BRT4342 and BRT4542 B-vent fireplaces are
approved for use with optional bi-fold glass
doors (see Accessories, page 31). Glass
panels may be ordered and installed anytime
after fireplace installation is complete.
Follow these steps to install left and right
panels:
1. With handle at the bottom, completely fold
panel on its hinges.
2. With handle facing center of firebox open-
ing, insert lower pivot pin on glass door
panel into hole in pivot plate on bottom edge
of fireplace opening (see Figure 32).
3. Keeping folded door tilted, slide upper two
pins into guide track found under upper
facial edge of firebox opening.
4. Tilt glass assembly fully vertical until outer
pivot pin snaps into mounting hole in up-
per spring clip (see Figure 32).
5. Once top and bottom pins are secured,
unfold door into the closed position.
Insert Pin Into Spring Clip
Spring Clip
Slide Top
Pin Into
Door Track
Insert Bottom Pivot Pin Into
Pivot Plate and Swing Door
Into Vertical Position
Pivot Plate
Figure 32 - Installing Optional Glass
Door
17