Removing The Power Cord Retention Clip; Operation; Remoting Management; Web - CyberPower 1U Series User Manual

Installation Guide

Removing the Power Cord Retention Clip

Step 1. Remove the Power Cord Retention Clip by pushing it to the right as shown
in the figure below.
Step 2. Remove the Power Cord Retention Clip by pulling the clip (show in the
image below) to the left.

Operation

Remote Management
The remote management function provides for monitoring of the ATS PDU
operational information, controlling outlets and utilizing SNMP functionality.

Web

Remote management can be performed via web interface. To access the web
interface, please follow the instructions below:
1. Enter the IP address of the ATS PDU into a web browser (Internet Explorer, Firefox).
2. Enter the user name and password of the ATS PDU device at the authentication screen.
Note: The default username is "cyber" and the default password is "cyber".
For additional information about the features and functionality of CyberPower
Management Console, please refer to the software Installation CD.

Telnet and SSH

The CyberPower ATS PDU provides Telnet and Secure Shell (SSH) as Remote Management
methods. Telnet uses user name and password as basic security while SSH has a higher
security level with encryption of the transmitted packets including user name, password, and
data. Configure the Setting of Telnet and SSH on the Web Interface. The default user name
and password is cyber/cyber.

SNMP

The CyberPower ATS PDU supports SNMPv1 and SNMPv3 Remote Management protocols.
Download the CyberPower MIB file and add it to a SNMP-supporting management software.
Default read/write community is public/privated for SNMPv1. SNMPv3 provides a higher
security level than SNMPv1 by encrypting the transmitted packet. Configure the settings of
the SNMPv1/SNMPv3 on Web Interface .
©2014. CyberPower Systems, Inc. All rights reserved.
13