Replacing Lcd Panel; Electrical Installation - CyberPower 1U Series User Manual

Installation Guide
Replacing the LCD Panel
Step 1. Use a slotted screwdriver to gently lift out the LCD panel.
Step 2. Disconnect the cable connector.

Electrical Installation

Step 1. Receptacle evaluation
Ensure that the plug type of your ATS PDU unit matches the receptacles
that you are using.
The ATS PDU must be plugged into a three-wire, grounded utility receptacle or
a UPS that is connected to a grounded utility receptacle. The utility receptacle
must also be connected to an appropriate branch circuit/main with fuse or circuit
breaker protection. Connection to any other type of receptacle may result in an
electrocution hazard.
Step 2. Plug the ATS PDU into the utility receptacle and/or UPS.
Step 3. Attach equipment
It is extremely important not to exceed the ATS PDU's maximum current
load (as outlined in the Specifications section). In order to determine
total load, use the LCD diaplay on the front of the ATS PDU to monitor
the load being attached.
©2014. CyberPower Systems, Inc. All rights reserved.
9