Local Management; Lcd Operation; Led Indicators - CyberPower 1U Series User Manual

Operation

Local Management

LCD Operation

The LCD display provides instant information, such as source condition, voltage and current,
for the ATS PDU. In addition, users can use the interface to configure each PDU parameters
and control each outlet on the switched ATS PDU.
A. Scroll Mode: The ATS PDU information will display in following order
automatically when "Scroll Mode On" is configured.
Source A information
Source B information
Device Load
Bank 1 Current (2U series)
Bank 2 Current (2U series)
Bank 3 Current (2U series)
Environment Status (Displays when the ENVIROSENSOR is connected)
B. Main Menu Map
Hardware Version
Firmware Version
About
Network Information
Serial Number
Preferred Source
Source Configuration
Load Configuration
Settings
Reset/Reboot

LED Indicators

Indicator
Flashing Green
Source
Load
Tx/Rx
LINK
Outlet
14
Outlet Control
LCD Settings
Reset All (ATS PDU, RMCARD and LCD)
Reset Except TCP/IP
Reset Account (User Name and Password)
Reboot
Status
Solid Green
Orange
Green
Orange
Red
Off
On (Green)
Flashing
On
Off
On
Off
A/B/None
Nominal Voltage
Voltage Range
Freq. Deviation
Sensitivity
Device
Bank/1/2/3
Device
Bank/1/2/3
Brightness
Scroll Mode
Screen Off
Selected source and power condition is normal.
Bankup source and power condition is normal.
Power condition is abnormal.
The aggregate current of each bank is normal.
Near overload.
Overload.
The ATS PDU power is off.
The ATS PDU power is on.
Receiving/transmitting data packet.
Reset finished.
Indicates the ATS PDU is connected to the LAN.
Indicates the ATS PDU is not connected to the LAN.
The outlet is on and providing power.
The outlet is off.
©2014. CyberPower Systems, Inc. All rights reserved.
Overload
Threshold
Near Overload
Threshold
Low Load
Threshold
All/Outlet 1-N
Description
Immediate On
Delay On
Immediate Off
Delay Off
Reboot
Delay Reboot