Environmental Monitoring (Optional); Device Reset; Unattended/Automatic Shutdown - CyberPower 1U Series User Manual

Operation

Environmental Monitoring (optional)

The CyberPower ATS PDU with an environment sensor (ENVIROSENSOR) installed,
provides remote temperature and humidity monitoring in a server closet and/or
datacenter. To connect ATS PDU with ENVIROSENSOR, use RJ45 Ethernet Cable
included with the ENVIROSENSOR. Plug one end into the Environmental port
on the RMCARD and the other end into the RJ45 port on the ENVIROSENSOR
(as shown in figures below). When the ATS PDU connected correctly to the
ENVIROSENSOR, users can see the temperature and humidity data with the Web
Interface. For further information regarding ENVIROSENSOR configuration please
refer to the Software Installation CD.

Device Reset

● To reset all the settings to default locally, use Reset function in the LCD display.
● To reset all the settings to default remotely, log in Web interface, enter the Reset
page and apply the function.

Unattended/Automatic Shutdown

PowerPanel Business Edition software automatically intitiates a graceful shutdown
on the operating system in an orderly fashion.
PowerPanel must be installed on every computer or server for which the shut
down is to take place. The computer will receive an SNMP message from the
ATS PDU and will perform the shut down according to the instructions provided,
including shut downs at exact time and dates.
Follow the directions below for setting up Unattended/Automatic Shutdown.
Step 1. PC Configuration
1. Install PowerPanel Business Edition Client on every computer/server that will
be part of the shut down process (Follow the instructions in the PowerPanel
Business Edition Client user manual).
2. Configure the settings in PowerPanel Business Edition Client. See the
PowerPanel Business Edition Client User Manual for additional help.
Step 2. ATS PDU Configuration
Verify that the IP address of all computers, that will be part of the shut down
process, are included in the Client List of the web interface (For additional
information, please refer to the user manual in the Software Installation CD).
Step 3. Notification
Notifying the computers of potential outlet shutdowns can be accomplished using
the following methods:
● Outlets Control Menu: Performing the task of turning off or rebooting outlets
● Scheduling Menu: Setting the application to perform the task of turning off or
rebooting outlets. The notification will occur prior to the scheduled date/time.
● Outlet Overload: In the event of ATS PDU overload, notification will be sent prior
to the ATS PDU shutting down.
©2014. CyberPower Systems, Inc. All rights reserved.
15