Table 2-12 Troubleshooting The Css Modules - Cisco 11500 Series Hardware Installation Manual

Chapter 2 Cabling and Troubleshooting the CSS
As implemented in WebNS 5.10 and greater, when a CSS module fails during
Note
normal operations, the CSS reboots.

Table 2-12 Troubleshooting the CSS Modules

Symptom
At boot up, the following
message appears:
CHMGR: Slot slot/subslot
had diagnostic failures -
NOT STARTING UP
During normal CSS operation,
the following message appears
and then, the CSS reboots:
ONDM: LifeTick for
Sub-Module in slot/sub-slot
- slot/subslot failed,
resetting..
During normal CSS operation,
the following message appears
and then, the CSS reboots:
ONDM: Port C Path Failure
%s, turning off Focus-C
Port.
78-17231-01
Cisco 11500 Series Content Services Switch Hardware Installation Guide
Troubleshooting the CSS Hardware Components
Recommended Action
Power down the CSS.
1.
Reseat the module in its slot.
2.
3. Power up the CSS to boot the module.
If reseating the module does not correct the
failure, replace the module. Refer to the
reference sheet that comes with the
replacement module.
If the module is not functioning, the left Status
LED will be Red and blinking slowly. If it is an
FEM, all of its Link and Duplex LEDs will
blink synchronously. When the CSS reboots,
the Status LED is off. Use the show chassis
command to verify the state of the module.
Replace the module. Refer to the reference
1.
sheet that comes with the replacement
module.
Power up the CSS to boot the module.
2.
The Switch Module in slot 1 failed.
Power down the CSS.
1.
Remove and replace the module. Refer to
2.
the reference sheet that comes with the
replacement module.
Reboot the CSS to boot the module.
3.
2-41