Troubleshooting The Css Modules; Table 2-12 Troubleshooting The Css Modules - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Hardware Installation Manual

Chapter 2 Cabling and Troubleshooting the CSS

Troubleshooting the CSS Modules

Caution
Note
78-13884-06
CSS 11503 and CSS 11506 module status is indicated by the Status LED on the
module front panel. For information about the module LEDs, see the
CSS 11503 and CSS 11506 Modules"
Table 2-12 provides suggestions for correcting problems that may occur with the
modules in the CSS 11503 and CSS 11506.
Always power down the CSS prior to removing or installing a module.
As implemented in WebNS 5.10 and greater, when a CSS module fails during
normal operations, the CSS reboots.

Table 2-12 Troubleshooting the CSS Modules

Symptom
At boot up, the following
message appears:
CHMGR: Slot slot / subslot
had diagnostic failures -
NOT STARTING UP
During normal CSS operation,
the following message appears
and then, the CSS reboots:
ONDM: LifeTick for
Sub-Module in slot/sub-slot
- slot / subslot failed,
resetting..
Cisco 11500 Series Content Services Switch Hardware Installation Guide
Troubleshooting the CSS Hardware Components
section earlier in this chapter.
Recommended Action
Power down the CSS.
1.
Reseat the module in its slot.
2.
3. Power up the CSS to boot the module.
If reseating the module does not correct the
failure, replace the module. Refer to the
reference sheet that comes with the
replacement module.
If the module is not functioning, the left Status
LED will be Red and blinking slowly. If it is an
FEM, all of its Link and Duplex LEDs will
blink synchronously. When the CSS reboots,
the Status LED is off. Use the show chassis
command to verify the state of the module.
1. Replace the module. Refer to the reference
sheet that comes with the replacement
module.
2. Power up the CSS to boot the module.
"Cabling the
2-39